That depends on the diameter of your rod which depends on the thickness of the material you are welding. An e-7018 1/16" rod start at about 70 amps. A 3/32 rod start about 90 amps. A 1/8 rod start at about 110 amps. These are ball park ranges and you will need to adjust to suit. When the scale from your test beads chips off easily you are exactly where you need to be with the heat.
6013 is normal arc electrode which is used for light jobs like sheet welding or tank making but when it comes to heavy construction jobs where strength required is more 7018(Low Hydrogen) Arc Electrode is used like boilers, heavy structures etc. Working with 6013 is far easier than 7018, which requires welder's skills. Neatness in finishing is also more with 6013 than 7018. any further info. on construction : nangalsuri@rediffmail.com Surinder Singh
what is the difference between 7018 and 7018-1
What the amperes of used electrode of 7018?Read more: What_the_amperes_of_used_electrode_of_7018
7018 structural 6010 root, 7018 cover for pipe
a welding rod
The GCF is 2.
a welding rod
Days of Our Lives - 1965 1-7018 was released on: USA: 6 May 1993
1040.
That depends on the diameter of the rod if it is 1/8" set your amperage between 125 and 140.
6010 penetrates deeper than 7018 does. It is a "fast freeze" rod - the puddle solidifies quickly. There's not much slag and it chips off easily. It also requires DC electrode-positive polarity. If you have an AC-only welder like a Lincoln AC-225, get 6011 which is almost the same rod but it will run on either AC or DC. Most guys who use 6010-series rods are welding pipe. Guys who weld bridge decking grab this rod first because of its penetration. 7018 is a rod with low-hydrogen flux. It produces a LOT prettier weld than the 6000-series rods do, but it's got to be stored in a rod oven because moisture in the air changes the way it welds. These are generally used for structural welding. These are two of the most general-purpose rods out there.
88