Want this question answered?
Gives us Copper loss
in short circuit test we apply rated current with the LV side shorted.so the applied voltage will be very low. iron loss depends on the applied voltage.so it is neglected
i hope this may be correct answer but iam not sure this is because if the short circuit test is performed first, because of induction effect some amount of energy is stored in the transformer or motor and while performing the open circuit test there may be a chance of getting error bcz of stored charge as in open circuit test the amount of current is vvv less wnen compared to short ckt by sandeepraj patnala
The open/short-circuit test on a transformer isn't 'needed'. It's only used if you want to find out the efficiency of a transformer.
If a megger test fails you have a short between the two wires or the wire to ground that you are testing. This short circuit has to be repaired before the equipment is placed back into service.
Is you'll need to short circuit between the drain and the source to identify FET test
earth continuity insulation resistance polarity
it shows that somewhere on the tail lighting circuit there is some kind of a short circuit,one can test using a multimeter to find the probklem..
by learning to understand the circuit
in the short circuit test we applied supply voltage on L.V side and short circuit the H.V side and connect the ammeter in H.V circuit to measure the short circuit current. with the help of s.c test we measure the copper losses in the transformers.
Short circuit test and open circuit test are widely used to test the efficiency of the transformer.
Yes, it possible to do a short circuit test of breakers at a project site.
A continuity test, just turn the lights on and if there is continuity the fixtures will let you know.
There are four watt-meters that indicates short circuit test. The four are method, procedure, calculations and fault.
Open circuit means the circuit is not continuous . A short circuit is continuous but has a fault connecting between either live to neutral or earth .As result of this we saw that this answer is unsufficent to explain short and open circuit on the other hand you can use this answer also like i did:)
If there is an electric short, the resistance of the circuit would be zero. So you can use an ohm meter to test it.
synchronous generator