At least 12 yrs old. you always have to wear a setbelt but you have to be 12 or older to sit in the front seat!
Everyone should wear a seat belt no matter what age.
It depends on what state your in but I believe that the no seatbelt law is nationwide in which case you will get a ticket if in the front seat of a car and are not wearing a seatbealt if your over the age set by the law. In the UK it is always an offence.
The timing mark for the Mazda 626 is in front of the engine. The marks for it belt are on the belt itself. The time for this can be set with a timing gun. A mechanic can set this for you.
Seat belts are legally required in most jurisdictions. Wear your seat belt.
The timing marks on your Isuzu 4hf1 engine can be set by looking at the timing marks on the timing belt pulley. The timing belt marks are facing towards the front of the automobile.
The timing marks on your Isuzu 4hf1 engine can be set by looking at the timing marks on the timing belt pulley. The timing belt marks are facing towards the front of the automobile.
The pump is set into the front of the engine block. You have to remove the timing belt to get to it.
The penalty for a seat belt violation in NC is $25.00, but there is a $75.00 court cost added on making it $100.00. I'm speaking from experience. There are no driving or insurance points at thiss time.
In 2006, 42,642 people were killed in car accidents. The NHTSA was able to gather seat belt data on 30,251 of the 42,642 car occupants that died in car crashes. Nearly 56 percent, or 16836 people, of the 30,251 with available restraint information were not wearing seat belts at the time of the fatal auto accident. In conclusion, there are about 1403 people died every month due to not wearing a set belt in 2006.
HI, There are definitely a timing belt and a water pump on the engine. The timing belt is behind the cover that is on the front of the engine and when there you will also find the timing belt tensioner, they come as a set when you purchase them. The water pump is also at the front of the engine and sits at the left of the timing belt cover as you look at the engine, the pump is driven by the belt, you can't miss it. Happy repairing and good luck.Steve H.
There are markings on the camshaft sprocket and the crankshaft sprocket. When one is lined up with a notch in the rear timing belt cover, the other should be lined up with the 10 degree mark on the front timing belt cover. Note that you will probably have to remove the front right wheel and splash guard to see one set of markings and the front timing belt cover to see the other.
The compressor pulley is the closest pulley to the ground in the set of pulleys driving the belt. Driver's side towards the front of the car underneath all of the pullleys and main drive belt.
The belt is behind the cover with the kick start on most 50cc remove the kick start cover with hand tools to prevent stripping. the variator is the front pulley with rollers behind it. using an air impact remove the front pulley its the easiest way, remove the front pulley and you will see a shaft, place belt on rear pulley (clutch) and pull tightly toward the front shaft. using a flathead screwdriver lightly pry the belt onto the shaft making sure not to harm the belt. it will take some stretching so it wont be easy at first. then replace pulley, tighten it down, replace cover and your all set to ride!