0
What else can I help you with?
How do you take out the factory radio in a 1997 maxima?
First off you get a small flathead screw driver and you pry up the plate to the outside of your shifter. Then you use that same screw driver to pry out above the a/c vent holes, but don't pull to hard they will break then go below the clock and pry that piece up it should come up with the a/c vents its one piece. Then pry out the piece surrounding the stock unit. there will be screws in one of the corners so be careful to see which one it is. After that you will need to pry the ash tray on the right side with the screw driver, and then get a Philips head and unscrew the screw holding it together. Then unscrew the 4 screws that are gold around the radio then your done.
How do you spell screw?
Screw is the correct spelling.
What is and gm and and gd in c program?
gd is graphics driver specifies which graphics driver to be used..... gm is graphics mode sets highest resolution for detected driver
How do you replace the rear wheel cylinder on a 1980 Chevy Malibu?
On the outside of the backing plate there is a metal C clip that can be removed with screw driver or pliers. Have spare C clips ready because of age and rust they usually break when removed.
How do you remove the 2006 sonata center fascia panel?
Well you have to removes the Center Faci with a flat head screw driver....there are clip holding it in place. It's recommended that you put tape on your screw driver so as to not scratch everything up. Then there is a connector on the back side and i believe 4 screws holding the Heater and A/C controller to the center facia. Once they are removed the unit should be out
Which tools are used in a mechanical workshop?
hammer swer driver and some c-4
Why C is called general-purpose language?
Cos it is used for different things.
What type of simple machine is used to make a catapult?
Catapults are simple machines for throwing things. They are comprised of levers, pulleys, and wheels and axles, which are all simple machines.
If driver a tells driver b that it is ok to turn left in front of driver a and driver b subsequently hits an oncoming driver c in the lane next to driver a is driver a liable for damages to driver c?
Left-turning vehicles are almost always liable for collisions with oncoming traffic. It is unlikely that driver C or driver B could win a court argument suggesting that driver B felt compelled to act under driver A's suggestion. It was, therefore, driver B's decision to act and will ultimately be responsible for damages to driver C. Cases where this may not be the case would be if driver A was a police officer or had some legal authority to compel driver B to act. But even in that case, it's highly unlikely that driver A would be determined to have any liability.
What does it mean when you used to hug a guy and talk with him a lot and all of sudden you guys stopped?
Means he lost interest b/c you took to long to screw him.
Class c driver?
Before you can become a class c driver, you must have your cdl license. The cdl license is given to you by the state you live in.
How do you disassemble front hub on 1985 Ford F-250?
If it's independent it's real easy Allen wrench regular screw driver c clip tool then you will see a fillip screw don't take it out it all comes out in one it mite take two regular screw drivers to pull it out then there will be two bearings and a lock nut do it one side at a time the first time I did it I took pics as I took it apart in case
