Want this question answered?
Generally the time between 1800 to 2100 hrs is considered to be peak hours where there is industrial and and residential load. Because the residential load increases in the evening hours in addition to regular industrial loads. Under only Industrial load, situation may be different depending upon type of industry and number of shift the industry operates. Rest of the hours are off peak
When there is the most traffic on a given day.
there are 12 hours in day time
At night
depends on the time of day and if its on weekend or weekday. weekdays - peak traffic time (starting from shj morning 6 am - 9 am) - 3 hours weekdays - starting after 9.30-10 am from shj - 2.5 hours weekends and starting around 12 or 1 afternoon from shj - 1.5 hours - 2 hours
Dr. Oz says "in the morning"
No. You can only use the concessionary pass in off-peak hours. Off peak hours are 9.30am until 11pm Monday - Friday, and all day weekends and bank holidays.
It is better to run it for short periods several time a day than it is to run it once. I run mine for 3 hours three times a day, avoiding the peak hot periods. Hatawa
An Equinox.
The book "Peak" by Roland Smith takes place in the present day. It does not specify a particular time or season within the story.
Most cities maintain flat-rate and time-of-use rate schedules for electrical service. Flat-rate schedules charge a consistent rate per unit of electricity consumed, while time-of-use schedules vary the rate based on the time of day electricity is used, with higher rates during peak hours and lower rates during off-peak hours.
Non-Coincident Peak (NCP) is the individual or actual peak demands of each load in an electrical system oftentimes occurring at different hours of the day. It does not necessarily fall during system peak. (This is what i understood about NCP...I gladly welcome corrections)