Ihave Nissan senta 2003 1.8 liters no haveaceleration nohave power when Iput the scaaner show me code PO6O5 YOU CAN HELP
If the Pcm sets a code saying that it's companion has dtc, you need to check the Ecm because it will have a code in it.If the Pcm sets a code saying that it's companion has dtc, you need to check the Ecm because it will have a code in it.
your main computer -pcm- is bad. This is an internal error which can only be repaired by replacement.
Trouble code P0606 means:PCM processor fault
Trouble code P1693 means: A companion DTC was set in both the ECM and PCM
I found the answer at http://www.obd-codes.com/p0601. It says that the Powertrain Control Module (PCM) needs to be replaced.
Trouble code P0606 means:PCM processor fault Might have to replace the PCM
P1693 : DTC in companion module.You need to check for codes in other computers (pcm or ecm) and repair their causes and then this code will clear itself.P1693 : DTC in companion module.You need to check for codes in other computers (pcm or ecm) and repair their causes and then this code will clear itself.
Trouble code P1621 means: PCM Memory Performance
P0601 is PCM internal processor failure.The PCM needs replaced.P0601 is PCM internal processor failure.The PCM needs replaced.
This code is set when the pcm gives 5v signal to ignition bypass and dose not get a return signal from icm, check wiring at pcm and icm possible icm fault, or crank sensor.
Pcm internal failure. The code P0601 ~ Internal Control Module Memory Check Sum Error. Chances are if you are getting this code then the ODB2 computer isn't storing codes like it should. It may even cause the vehicle to run bad or not run at all.
It is unlikely that they are related. The code P0601 indicates the pcm failed a self test (internal problem). An a/c fan that only works on high is almost always caused by a faulty blower motor resistor.