Fuel Filter Location
The fuel filter is located along the frame rail under the vehicle and is accessible only from underneath the vehicle.
__________________________________________________
Fuel Filter Removal & Installation
1. Disconnect the negative battery cable.
2. Properly relieve the fuel system pressure.
3. Raise and safely support the vehicle securely on jack stands.
4. Remove the fitting safely clips by gently prying them off. Usually they are held to the fuel lines by small retaining straps, however take care not to lose them.
5. Insert fuel line disconnect toll T90T-9550-S into the quick-connect fittings on the fuel lines.
6. Push the tool into the spring lock coupling and release the garter spring and separate the fitting.
Twisting the line sometimes aid in releasing stubborn connections.
*** Caution ***
Fuel will most likely run out of the line after it is removed from the filter.
7. Repeat the procedure for the other fuel line.
8. Grasp the fuel filter and carefully pull it straight out of the retaining clamp.
To Install;
9. Push the filter into the retaining clamp aligning the front lip on the filter into the groove.
10. Attach the fuel lines to the filter until an audible click is heard from the connection. Sometimes the click is very quiet, so test the fitting by gently pulling on the line to see if it comes loose.
11. Attach the fitting safety clips by snapping hem into place over the fittings.
12. Lower the vehicle.
13. Connect the negative battery cable.
14. Start the vehicle and check the filter and lines for leaks.
How do you change the fuel filter on a 1992 Chrysler New Yorker? Do you need a special tool to remove the quick disconnect? How do you change the fuel filter on a 1992 Chrysler New Yorker? Do you need a special tool to remove the quick disconnect?
You need to go up to AutoZone and buy a fuel filter line tool. About $10.
first need spl.tool to releace fuel lines from filter. very ez when you get tool.
You'll need a wheel chock, catch pan. a fuel line tool and a new fuel filter.
The fuel filter is located on the driver's side frame under the car and forward of the gas tank. You will need a special tool to release the fuel line from the filter.
You don't need any. You should be able to replace its fuel filter with a screw driver and pair of pliers.
under the driver door and you will need the tool to change it with it run about $7:00 and the filter run about $10:00 the boxs the tool come in will tell you how its works good luck
You do NOT need a special tool to remove the filter http://www.youtube.com/watch?v=0FqLKzINM6s -RC-
First you have to relieve the pressure on the fuel system. Then you will need a special tool they sell at all auto parts stores. The tool releases the fitting on both ends of the filter. The new filter simply clicks into place.
Relieve the fuel pressure at the fuel rail. The fuel filter is located under the car on the driver's side frame just forward of the gas tank. You will need a special tool to remove the quick disconnects at the filter.
is a special tool needed
You need the Dodge fuel line release tool.