Want this question answered?
Adding, subtracting, multiplying, dividing, and measuring
That's a graphical solution.
There are a few reasons why it is important to add only one third of the diluent to the medication bottle at first and save the remaining two-thirds until after the medication has been vigorously shaken. First, adding only a small amount of diluent at first allows you to better control the final volume of the solution. This is important because the final volume of the solution will determine the concentration of the medication, and it is important to ensure that the solution has the correct concentration. Second, adding only a small amount of diluent at first allows you to more easily mix the medication and diluent together. This is because adding all of the diluent at once can make it difficult to mix the two substances together thoroughly. By adding only a small amount of diluent at first and then shaking the bottle vigorously, you can ensure that the medication and diluent are well mixed. Finally, adding only a small amount of diluent at first can help to prevent the solution from foaming or frothing. This is because when a medication is mixed with a diluent, it can cause the solution to foam or froth, which can make it difficult to accurately measure the final volume of the solution. By adding only a small amount of diluent at first, you can help to prevent the solution from foaming or frothing, which can make it easier to accurately measure the final volume of the solution.
well, its usually a numerical problem where you will probably end up adding the numbers together to end up with the correct answer. Of course the alternative to this, the subtracting probability, is where you would probably have to subtract to end with the correct solution.
The correct solution to the expression 3 plus 5 times 2 is 13. This is calculated by first performing the multiplication, which gives 10, and then adding 3, resulting in 13.
Adding a base
A concentrated solution can be weakened by adding more of the solution material (usually water) to dilute it.
Adding an acid to a solution will lower it's Ph, but adding a base will raise it's Ph.
It increases the mass.
To find the __________ solution when adding vectors, simply draw and label the given information..... graphical.
When adding a strong acid to an acidic solution pH decreases. Adding a strong base to an acidic solution the pH increases.
Adding more solute to a saturated solution causes the solution to become supersaturated. In other words, the solvent does not completely mix with the solute.
Adding more solute the solution become supersaturated.
Adding, subtracting, multiplying, dividing, and measuring
it will turn a yellow colour
the temperature at which the solution freezes is lowered.
the temperature at which the solution freezes is lowered.