Basically a 10mm wrench to remove the Hot wire from the battery, which is bolted to the starter, also, the solenoid wire is clipped on, and the 14 or 17mm bolts holding the starter in. i cant remember what size exactly, id say 14mm. just run you hand back there and you can feel the wires. and the 2 bolts. disconnect battery first
socket rench and a c-clamp
Common mechanic's handtools. No special tool is needed.
The tools needed for an oil change tend to be common tools. A floor jack is needed to access the oil pan. A pan which is used to drain oil into. A wrench and socket set is used to remove and replace the oil cap.
a wrench and some plyers.
No tools needed, that 1997 Cadillac Deville doesn't have a timing belt.
all you need are wrenches to disconnect battery cables, and sockets and extensions to remove starter blots from starter
No, no special tools needed, just common hand tools.
No special tools needed.
the bolts that hold the starter on should be 9/16, so just a wrench, or socket/ratchet. the wires should be 3/8. if not, you can usually take those off with a pair of channel locks, or adjustable pliers.
basic tools are all that are needed its a simple job. They are disc type brakes.If you can do the front, then you can do the rear.
You will need a hoist, a socket wrench set and a torque wrench. You will also need the brake pads, brake fluid and brake grease.?æ
simple fix tools time and patience. Book on repair will guide you in all.
To remove car parts, a person must have the right tools. For a person to remove a starter on a 1996 Saturn they would need a 1/2 inch socket, a 4 inch extension, a wrench, and pliers.Ê
about 30 min if you have tools available
No special tools are needed!
You need speciality tools and take it to a dealership that can work on it cause you can snap the crank
where is the starter located on a 95 ls 400 lexus? and what tools a need to change it? underneath the intake, sucks but it can be changed out within a couple hours if you are knowledgeable
A flat head screwdriver.
If by that, you mean making you spawn with certain tools, then put them in Starter Pack.
a ratchet, 3/8" socket (for the power cable), and either 1/2" or 5/8" socket for the 2 bolts that hold the starter in place.
no special tools are needed
Jack-up, wrench, anyway, it's very difficult to change it
You need a 3/8 Allen wrench.
Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.Change the measurement units under Tools and options.
A set of Metric wrenches/metric sockets a jack and that's about it once you separate the tranny it slides right off. Remember to pick up a big 32mm socket for the drive axles toughest to break loose.