A lug wrench, an Allen wrench 3/8 and a big. screwdriver
Tools needed to replace front brakes 2002 Ford Focus?
The tools required to replace a front brake pad and rotors on a 2000 Jeep Grand are lug wrenches, a jack, jack stands, and a C-clamp. You also will need a wrench and a turkey baster for drawing out old brake fluid.
special tools are required to do this job.slide hammers impact tools.yhis is not a job for diy!!
lots, replace pads and shims, clean and pack wheel bearings with grease and replace grease seals, resurface/replace rotors
Remove old one and replace. Several specialty tools are required. The last step is a front end allignment.
On the Bravada as with any vehicle the brakes can be replaced with standard tools with few exceptions. When you purchase your new brake parts the guy at the counter will know if you need any special tools and most parts houses will loan or rent you the special tool you need.
to change brakes on a 2005 trailblazer do i need a star bit to remove cailber pins
You can replace the front bearing on 2003 Citroen Relay using air tools.
To required tools for a lawyer include knowledge of the law and the ability to research. They must also be able to speak in front of groups.
With tools and alot of patience
Do I need any special tools to replace front wheel bearings on a Saturn 2002 L200?Also what is the procedure for doing so?
The tools you would need to replace front brake pads are, a wrenche (size varies depending on vehicle type), a clamp tool, and brake pads.
The oil pan must be removed. No special tools required, just normal mechanics tools.
Visegrips, a cigarette and beer.
just pull out the socket and the rubber boot, no tools required
The PCV just slips out and slips in; no tools required in most cases.
If you're asking, you should take it to a mechanic. Honest, you don't want to tear into that. Special tools are required, you have u-joints, brake lines, torqued bolts - it's a mess.
The 4Runner doesn't have struts; it has coil-over shocks in front. After removing the old shocks a spring compressor is required to remove the springs and install them on the new shocks. Take it to a front end shop that has the proper compressor and tools; it's very dangerous if you don't have good equipment and experience. The rear shocks are easy to replace by yourself.
the only tools need are a 17 inch socket a rachet a "C" clamp to push the piston back in.
Unless you have the knowledge and tools to handle it have it done. YOU COULD GET SERIOUSLY HURT
The brakes on the Villager are as straight forward as the brakes on a 1965 Mercury. Only normal brake tools are required.
To replace the front brake pads on a 2003 Mitsubishi Galant you will only need a few tools. You will need a jack, tire blocks, a large C-clamp, and a 14 mm socket.
It is on the left side of the block, only tools required are 13 and 15 mm sockets and wrenches.