Fuel Filters

What tools do you need to change fuel filter on 1997 Chevy Cavalier how do you change it?

131415

Top Answer
User Avatar
Wiki User
Answered
2005-09-30 19:12:21
2005-09-30 19:12:21

One side should use metric wrenches and the other is probably quick clip connectors; squeeze ears,push together then quickly pull apart.I hate em.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


change out all the spark plugs,oil and air filter including the oil filter located under the engine you will need a floorjack and some tools. you will also need a filter wrench1


carefully with tools and the battery disconnected


an automotive shop should have the tools u need its a little plastic thing that goes over the fuel line and releases the clip inside the filter


One tool, a telephone book. Call a mechanic and get the job done correctly.


Just did it on my 94RS its simple, its in line under car just in front of rear axl, tools used were 2 wrenches and needlenose plyers.


what tools i need to change the brake shoes for a cavalier 2003


what kind of tools do i need to change a fuel filter on a 2000 cougar


remove the oil filter then swear a lot while you try to do a job that is no fun even when you know how to do the job and have enough tools and patience. remove the oil filter then swear a lot while you try to do a job that is no fun even when you know how to do the job and have enough tools and patience. remove the oil filter then swear a lot while you try to do a job that is no fun even when you know how to do the job and have enough tools and patience.



If you have the tools and the knowledge, yes


oil filter toolYou would need a oil filter wrench, a jack that's all you need to change the filter.


No, special tools are not needed to change a fuel filter on a 1987 - 1990 Chevy Celebrity. The proper size of open end wrenches work fine.


YES I CAN! u should have a shop do it because of the time and precision needed as well as specialty tools and equipment.



The axle generally goes for 160.00 plus labor of about an hour. or cheaper if you have the tools to do it yourself.


Here is a link with pictures, tools needed and everything to do the job. http://www.v6z24.com/howto/heatercore


Under the cab in the frame rail. You need special tools to change it which are available at the parts store. They should show you how to use them.



If you don't have the tools and/or know-how, it could be very difficult.


The procedure is to take it to a professional. If it needs recharging, you have a leak that needs fixing. You also do not have the skill, nor the tools necessary to do this correctly or safely.




It is located at the rear of the vehicle by the wheel base. You will see it's a round cylinder like filter. All you need is a couple of open ended wrenches. Be sure to relieve the fuel line pressure FIRST!!!! You do this by removing the fuel pump fuse underneath the dash driver side, fuse box. It's marked as F/P. Also, it wouldn't hurt to remove the fuel cap where you put gas in the vehicle. FUEL LINE pressure FIRST!!!!


You will need a one inch socket and ratchet. You also might need a mallet. The socket and ratchet will be needed to remove the lower control arm nuts. The mallet might be needed to loosen the control arm.


Make darn sure it isn't the tire first. Take the strut off, and have the bearing pressed.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.