0
A lighting circuit would be a parallel circuit.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What type of switch would be used to control a lighting load from one control point?
In this type of situation, where there is more than one lighting circuit, a lighting contactor would be used. These types of contactors can be obtained in four and five pole configurations. Make sure that the contactor is rated for lighting loads and not motor loads. A normal switch, single pole single throw, would be used to switch the contactors on and off. A single switch could then be used to control as many contactors as you need to operate the lighting circuits.If there is just one lighting circuit, the total circuit amperage must be known, then the switch would be sized to the amperage of the circuit.
What does the term 'triac' means?
A "triac" is a type of thyristor designed for electronic control of the current supplied to a circuit, used especially in dimmers for lighting systems.
Can a 30A dedicated circuit for a heater have the heater removed and the circuit used for lighting?
Yes provided the voltage is compatible.
What is the right circuit break to be used for lighting circuits?
Usually 15A or 20A, but it depends on the wire used.
What type of wiring would be used for exterior home lighting?
Use a # 12 exterior grade or romex
Can one use 1 circuit of a 3 wire plus ground 2 circuit cable as a GFI circuit with the other as a lighting circuit?
A GFCI can not be used on a three wire branch circuit. It has to be on a single two wire circuit.
What is the best way to use quoizel lighting?
In my opinion I would say not use use quoizel lighting for your patio. These types of lighting are more used for things like chandeliers. You could but if you can find something else, I don't recommend using this type of lighting.
What is a crystorama, and is it a company?
Chystorama is a type of chandelier lighting for residential or commercial locations. It is a unique type of lighting that is often used by interior designers.
What type of pulley is used in lighting material?
block and tackle
Which type of circuit breakers used in EHT applications?
SF6 circuit breaker
What is used in an electrical circuit to prevent a short circuit?
difference between p type and n type semiconducter materialAnswerInsulation is used to prevent a short current. To protect the circuit should a short-circuit fault occur is either a fuse or a circuit breaker.
Where can a circuit with two lamps with single pole switch fluorescent lamp with two 2 way and an intermediate control can be used?
This type of circuit would never be used. The two way fluorescent system would depend on the voltage being supplied by the two lamp circuit switch. If the switch turns off the two lamp circuit the rest of the circuit with the fluorescent fixture would become inoperable.
