you would use 5W-30W have the same car
The starter on a 1994 Oldsmobile Cutlass Ciera is located on the driver's side of the engine towards the bottom of the engine. It is behind the crankshaft sensor and the fusible links.
16.5 gal
The low pressure valve to put in 134a on a 1994 Oldsmobile Cutlass Ciera V6 is on the passenger side of the engine compartment. It is about 12 inches below the alternator.
The 1994 Oldsmobile Cutlass turn signal relay switch can be found below the dashboard. The relay switch will be on the drivers side of the passenger compartment.
cracked or broken wiring, blown fuse
The 1994 Oldsmobile Cutlass cam sensor is located on the back of the left cylinder head. The cam sensor should be labeled as such.
the horn relay switch is in the fuse panel or it should be on the horn wires itself
where is cam senor on a 91 cutlass ciera 3300
On a 1994 Oldsmobile Cutlass Ciera, the starter is located on the lower passenger side of the engine, mounted to the transmission bell housing. To access it, you may need to lift the vehicle and remove the protective splash shield if equipped. Disconnect the battery before attempting any work on the starter to ensure safety.
I have yet to identify which relay is specifically for the fuel pump,however, the relays are mounted on the passenger side of the radiator .
The 1994 Oldsmobile Cutlass Ciera Cruiser with a 3.1L engine typically requires about 2.5 to 3.0 pounds of R-134a refrigerant for its air conditioning system. It's essential to check the specific service manual or labels in the engine compartment for the exact amount, as it can vary slightly depending on the vehicle's specific configuration. Always ensure the system is properly evacuated and recharged by a qualified technician.
where is the coolin fan relay located in a 1994 Oldsmobile cutlass located