0
What else can I help you with?
Where is the tps located in a 1993 Oldsmobile cutlass ciera?
Its located on the bottom of the throttle body right next to the fuel pressure valve.
Where is egr valve on 1993 cutlass ciera?
The EGR is the acronym for exhaust gas recirculation valve. The 1993 Cutlass Ciera does not come equipped with an EGR valve.
How do you locate and replace the PCV valve on a 1989 Oldsmobile Cutlass Ciera?
The PCV valve is located in the rocker cover (valve cover) Once you locate it pull up on the hose that is connected to it. Remove the PCV valve and put new one in. Reinstall in rocker cover.
Where is the oil pressure switch located on a 1995 Oldsmobile Ciera?
Under hood, center, front engine area, below valve cover, mounted in engine block.
Where is modulator valve on a 1994 cutlass ciera?
underneath the green and red stripy cats hat by doctor seus
Where is the modulator valve located on a 1992 Oldsmobile cutlass located?
In the transmission in front of the modulator
Reasons for poor idle quality of a 1995 olds cutlass ciera?
it's the idle control valve, $60 part, or the computer.
Where is the purge valve located on a 1996 Oldsmobile Cutlass Supreme?
wher is the pcv located on a 1996 olds cutlass supreme 3.4 l engine
Which line is the high pressure line on the air conditioner cooling system of an 1992 Oldsmobile Cutlass?
Most high pressure lines have a red cap on them, and they are usually smaller in diameter. It runs from the condenser to the TX valve/Evaporator.
Where is the pcv valve located on a 1991 Oldsmobile cutlass supreme?
its in back valve cover at fire wall i removed the plenum from the intake manifold to get at it.
How to bleed the brakes on a 1993 Oldsmobile cutlass ciera?
To bleed the brakes on a 1993 Oldsmobile Cutlass Ciera, start by ensuring the vehicle is on a level surface and the parking brake is engaged. Begin at the wheel furthest from the master cylinder, typically the rear passenger side, and use a wrench to open the bleeder valve while an assistant presses the brake pedal. Close the valve before they release the pedal, and repeat until no air bubbles appear in the fluid. Move to the next furthest wheel and repeat the process, finishing with the driver’s side front wheel. Always check and refill the brake fluid reservoir as needed during the process.
Where is PCV valve located on 1989 cutlass ciera?
On a 1989 Cutlass Ciera, the PCV (Positive Crankcase Ventilation) valve is typically located on the valve cover or the intake manifold. You may find it attached to a rubber grommet on the valve cover, with a hose connecting it to the intake system. To access it, you might need to remove any obstructing components, such as the air cleaner assembly. Always consult the vehicle's service manual for specific details related to your engine configuration.
