answersLogoWhite

0


Best Answer

You don't put motor oil in a lower unit. Get a few tubes of lower unitgear lube from a marine supply dealer and a device to squirt it in. Remove the screws at the top and the bottom. Drain the old lube out. squeeze the new lube in from the bottom till it comes out the top, then re install the screws. Do this at the end of every boating season.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What weight oil goes in the lower unit of a mercury outboard?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much gear oil goes in a 125 hp mercury outboard?

22.5 fluid ounces (or 666 ml's) per our 1994 Mercury 125 outboard manual.


What spark plug goes in 2001 mercury outboard 125 hp outboard motor?

Ngk bpz8h-n-10


Why is your mercury outboard beeping?

a constant beep is the overheat alarm a beep that goes in and out is low to no oil alarm


What spark plug goes in a 1999 mercury 125 hp Outboard?

ngk bp8h-n-10


Which plug wire goes to which plug on a mercury outboard?

In order to correctly answer this question, the particular engine referred to must be made known.


What is the oil weight goes in a 1998 mercury villager?

According to the 1998 Mercury Villager Owner Guide ( 5W-30 ) is the preferred oil


Where can you find a wiring diagram for a kill switch for a 9.8hp mercury outboard?

I don't know where to find the diagram, but one wire from the button goes to the stator brown lead, (at terminal block under flywheel). The other lead from stop button, goes to ground.


How fast a 8hp outboard will go?

There are too many variables here to give you a solid answer, but my 21 foot Santana Sail Boat (weight approx: 1600lbs) goes 8-10mph.


What does it mean when the gears don't engage on a 1977 mercury boat?

Adjust or change the cable that goes from the shifter to the transmission or engine, unless it is an outboard, and then I am not sure. On the outboard, as already mentioned, check the shift cable first. If no problems are observed, the the problem is most likely in the gearcase. If the gearcase has been removed, it is also possible that the shiftshaft is not properly, or at all, engaged with the lower shiftshaft. Should the above checks prove ok, then worn gears, clutch, or internal gearcase damage is probable.


What goes in a thermometer?

Mercury.


What nicknames does Jason Mercury go by?

Jason Mercury goes by Jmerc.


What nicknames does Daniela Mercury go by?

Daniela Mercury goes by Rainha do Ax.