On a star delta starter a motor overload or a motor going to ground and cause a short circuit will cause the overload protection to trip. These overloads have to be reset before the motor can be restarted.
A short, which will trip the main breaker.
One of the three phase contacts in the star contactor could be burned open or just open not allowing the motor to start because of a single phase condition. The time interval between star and delta connections could be small enough that the motor heaters will not catch the single phase condition and trip. When the motor goes into delta (which is now across the line starting) all of the three phase contacts in the contactor close and the motor starts.
The Okavango Delta would be a great diverse area to take students on a field trip provided that the school has funds for a field trip that can reach to Africa.
If the fault is a direct short to ground, the fault current can be high enough to trip the upstream protection.
The only thing that will trip the starter, is the load of the motor. Check the motor leads to make sure you have not crossed them over coming from the motor junction box. If the motor current is normal nameplate full load amps when run across the line then reduce the timing of the timer on the switch over from star to delta.
No, that alone would not cause a GFCI to trip because that is the proper way to wire a panel.
One or more reasons may be:The load of the motor (HP) is too large for the output of the generator.The generator's breaker is sized too small for the generator's full load output.Short circuit in the motor.Megger the motor first to see that the windings have not grounded-out. Windings to ground should be above 5 meg.
What is the cause of a compressor if not trip to its overload
You can't , without knowing which winding is which . 9 times out of 10 it will just trip your protection device if it's connected wrong . U need to watch for it starting i'n forward i'n star but when it kicks into delta goes i'n reverse . If u take the motor to a winding shop they should be able to identifie which winding is which .
The trip button is integrated in the instrumental panel (where speed is shown, rpm etc). You can activate by pressing on plastic cylinder sticking out of the panel.
Yes, Delta does offer online check in. Visit Delta.com and they can walk you through the steps to checking in online for your trip.
Egypt and any place in the delta.