A vinyl tile glue will do that -Mapei Ecobond, in Home Depot.
It depends on the type of ceramic adhesive. Many of them can be taken off tile with lacquer thinner on a rag.
Epoxy or silicone.
if it is glazed ceramic tile - let it dry fully (I let mine dry for a few weeks) then CAREFULLY pop the glue off with a chisel. Hold the chisel so the flat end is up and the beveled end is on the tile and gently push the tip of the chisel into the (expanded) gorilla glue. hit the end of the chisel with the palm of your hand and the glue will pop off the ceramic.
yes
What glue is it? Im not there to see it, so you will need to tell me.
I would use PL300 or a similar general adhesive.
Yes, it is possible to install ceramic tile over existing ceramic tile, but it is important to ensure that the existing tile is in good condition and properly prepared before doing so. Proper surface preparation and adhesion are key to a successful installation.
Any epoxy or LePage Extreme or PL200 would work for that.
Yes you can if you first rough up the ceramic by sanding it. Use a vinyl mastic like Mapei Unibond.
Yes, soften it with Goof Off, then scrape it with a craft knife, blade almost parallel with tile.
To apply peel and stick tiles over ceramic tile, first clean the surface thoroughly to remove any dirt or debris. Next, measure and cut the peel and stick tiles to fit the ceramic tile. Peel off the backing and press the tiles firmly onto the ceramic tile, smoothing out any air bubbles. Finally, use a roller to ensure the tiles are securely adhered to the ceramic tile surface.
form_title= Ceramic Tile form_header= Install ceramic tile in your home! Where would you like the ceramic tile installed?*= _ [50] Do you need the ceramic tile to be custom cut?*= () Yes () No () Not Sure What type of tile do you what installed?*= _ [50]