Want this question answered?
You'll fry it
Appliance police will not come to your home to determine if your microwave is plugged into a GFCI outlet.The important question is, what is the potential for electrocution with your microwave in the event of a malfunction?If a person could reach the microwave with one hand and a potential ground (sink, concrete floor) with the other hand or a foot, the microwave should be plugged into a GFCI. However... if you research local ordinance and find that your microwave should be plugged into a GFCI, then that's what you should do.If your microwave is plugged into a receptacle on your kitchen countertop it should have GFCI protection.The National Electrical Code (US) states:Section 210.8 Ground-Fault Circuit-Interrupter Protection for Personnel. (A) Dwelling Units. All 125-volt, single-phase, 15- and 20-ampere receptacles installed in the locations specified in (1) through (8) shall have ground-fault circuit-interrupter protection for personnel. (6) Kitchens - where the receptacles are installed to serve the countertop surfaces.
First, someone would have changed the plug before that would be possible. 240 Volt receptacles do not accept 120 Volt plugs. Second, IF someone changed the plug on the compressor, then plugged it in using both legs of the 240 Volt circuit, the compressor motor would self destruct instantly; internal wiring would burn and you would smell the burning insulation.
The current will remain in a 220 volt circuit as long as the circuit load remains in the circuit and the circuit remains closed.
Yes, a 110 volt device can be plugged into a 125 volt receptacle. The voltage rating on the receptacle is only there as the highest voltage supply that the manufacturer recommends their equipment be connected to.
You'll fry it
Appliance police will not come to your home to determine if your microwave is plugged into a GFCI outlet.The important question is, what is the potential for electrocution with your microwave in the event of a malfunction?If a person could reach the microwave with one hand and a potential ground (sink, concrete floor) with the other hand or a foot, the microwave should be plugged into a GFCI. However... if you research local ordinance and find that your microwave should be plugged into a GFCI, then that's what you should do.If your microwave is plugged into a receptacle on your kitchen countertop it should have GFCI protection.The National Electrical Code (US) states:Section 210.8 Ground-Fault Circuit-Interrupter Protection for Personnel. (A) Dwelling Units. All 125-volt, single-phase, 15- and 20-ampere receptacles installed in the locations specified in (1) through (8) shall have ground-fault circuit-interrupter protection for personnel. (6) Kitchens - where the receptacles are installed to serve the countertop surfaces.
power/voltage=Amperage. If the circuit is rated above 33.4 Amps it can.
A volt can not be connected to a circuit.
temporary it blows or KABOOOMM....
First, someone would have changed the plug before that would be possible. 240 Volt receptacles do not accept 120 Volt plugs. Second, IF someone changed the plug on the compressor, then plugged it in using both legs of the 240 Volt circuit, the compressor motor would self destruct instantly; internal wiring would burn and you would smell the burning insulation.
If the ballast of the HPS fixture has a 120 volt tap then, yes it can be plugged into a 120 volt receptacle.
It should be ok
zzzzzzzzzzzAAAAAAAAAAAAAAAPPPPPPPPPP !!!!!
The current will remain in a 220 volt circuit as long as the circuit load remains in the circuit and the circuit remains closed.
Yes, a 110 volt device can be plugged into a 125 volt receptacle. The voltage rating on the receptacle is only there as the highest voltage supply that the manufacturer recommends their equipment be connected to.
A map of a circuit is not a volt. A map of a circuit is referred to as a schematics chart. The schematics chart details the path of the circuit, from beginning to end.