0
What will happen if someone only connect one of the wires to the bulb holder?
Wiki User
∙ 11y ago
If someone only connect one of the wires to the bulb holder, the circuit will be open and the lamp will not light. This is the same principal that a switch in the circuit does. It opens and closes the circuit.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you wire a two pole lamp holder with a pull chain when you have four wires coming out of the wall?
Assuming the wires are 2 blacks and 2 whites, and assuming one set provides power and the other set continues the circuit downline, you connect both black wires to the black wire of the lamp holder and connect both white wires to the white wire of the lamp holder. Turn the circuit off before making these connections.
How did we used to connect wires?
With Junction boxes.
What will happen if wires are not insulated?
what may happen if wires are not insulated
Can you connect copper wires to tin coated copper wires?
Yes. You can twist them together and wire nut them, or solder them together.
How does a wire connect to a bulb?
You take a wire and stick it to the positive end of the batter. Then connect another wire to the negative end of the battery. Connect both wires to the lightbulb.
How do you wire a two pole lamp holder with a pull chain when you have four wires coming out of the wall?
Assuming the wires are 2 blacks and 2 whites, and assuming one set provides power and the other set continues the circuit downline, you connect both black wires to the black wire of the lamp holder and connect both white wires to the white wire of the lamp holder. Turn the circuit off before making these connections.
How do you connect copper wires to battery?
i will tell you how if you tell me what this project is called,it uses light bulb, copper wires,holder,6 volt battery.
How do you tell if the spark plug wires are on correct on a 4-cylinder Toyota Camry?
Spark plug wires are made in the way when it's really hard to connect wires in a wrong order, they have certain length and a special holder which prevents mistakes during repair process.
Can you use T12 lamp holders with T8 lamps when you change to T8 ballast?
Absolutely. Only you need connect together two wires coming from each lamp holder (shunt).
How do you connect wires?
plug them in
How do wires connect?
plug them in
Why would you connect wires to a penny?
Answer why does the person who made a circuit a probably connect the wires to a penny
Find out what wires do?
Wires just connect electricity cords/outlets.
How many wires connect to a Nissan pickup starter?
2 wires
How are sparks made?
from the wires and they connect them
What happens when you connect a 110 volt motor to 220 volts?
On a three wire supply system if you connect the two 110V wires together and they are across the phase they will short out and trip the breaker. If the two 110V wires are supplied from across the phase and connected to a motor then the motor will run. If the 110V wires are on the same phase nothing will happen.
If the old block heater cord of a 1988 Honda CRX had two wires and the new end has 3 which colored wires connect the new connector to the old one?
Connect to two wires you have to the the spade connectors and forget the ground connector. The spade connector wires should be black and white. Black to gold and white to silver. If the wires coming from the heater happen to be red and white, then red goes to black. You could buy a simple lamp cord which has only tow wires.
