Preguntale al maestro de motores 2 el chamo
The centrifugal switch is likely to wear out and require replacement. It could also create a spark which could cause fumes from the oil inside the motor
Aprox 75%
Push-To-Make switch is a switch in which pressure is applied to the switch for it to let the electricl current flow through.
This should not happen, change the switch out for a new one.
The centrifugal switch on a motor's start winding should open at 75 to 80 percent of the motors run speed RPM.
Preguntale al maestro de motores 2 el chamo
I think you over-laod and blow the capacitor
Check
A centrifugal switch, once the motor reaches near run speed, centrifugal force causes a set of contacts to open and disconnect the start capacitors. Some larger motors use a contactor which is disconnected by the centrifugal switch.
The centrifugal switch is likely to wear out and require replacement. It could also create a spark which could cause fumes from the oil inside the motor
Aprox 75%
The hermetic compressor cannot use a centrifugal switch like an open motor because it will disrupt the start winding. Hermetic compressors work through insulated motor terminals, and not in the open.
Closing a switch in an electrical circuit will complete the circuit. The supply voltage will then be applied to that circuit, and current will flow through that circuit.
In a single phase electric motor, the centrifugal switch allows the start winding to be energized through the start capacitor when the motor is starting. This gives an out of phase magnetic field that, along with the in phase magnetic field from the run winding, helps the rotor to begin spinning. Once the rotor reaches a certain speed, the centrifugal switch changes state and cuts off the start winding. At that point, the motor continues running only through its run winding, and inertia keeps the rotor properly phase biased relative to the run winding's magnetic field.
Push-To-Make switch is a switch in which pressure is applied to the switch for it to let the electricl current flow through.
If the dryer has a button that says "Push to Start", and you push it and nothing happens, the centrifugal start switch is bad. If you can get to it, and it is an "assembled" switch (as opposed to molded or sonically welded), you can disassemble it and clean it with electrical contact cleaner (available at the large retailers). That will fix it for awhile - possible a long while. But it is not terribly expensive, and to order the factory specified replacement switch for it online is a permanent fix.
governor on side of transmission inoperable,not spinning its a centrifugal switch.