Want this question answered?
I x R = E 20 x 6.4 = 128 Volts
Yes, we use AC (alternating current) in our homes, the current changes direction 120 times a second.
The formula you are looking for is E = W/I.
To limit the current through the lamp when the gas ionises and conducts.
Your standard light bulb where a filament is heated by a current passing through it. The heated filament then gives off light.
I x R = E 20 x 6.4 = 128 Volts
brightness will decrease
Lamps use what is called a power cord. Power cords connect the appliance (in this case, a lamp) to a wall socket and the electrical field causes the filiment in the light bulb to beam.
The battery provides the current and the energy; the lamp consumes the energy when the current goes through it; the copper wire conducts the current; and the switch lets you close or open the circuit (so that current passes, or doesn't pass, through).
A parallel circuit is one in which there is more than one current path. An example might be several light bulbs in a house, all of which provide a path for electric current. The advantage is that any of the lamps can be turned on or off without affecting the current flow through any other lamp. A series circuit is one in which the current has only a single path through multiple components. An example might be two resistors, one after the other. Both will have the same current through them but they may have varying voltages depending on their resistance. Another example of a series circuit is a houehold lamp and a light switch. When the light switch is open, no current flows through it and therefore, no current can flow through the lamp either. When the switch is closed, current will now flow through the switch and the lamp.
Yes, we use AC (alternating current) in our homes, the current changes direction 120 times a second.
Open and closed does not refer to electrical current or the flow of electricity. Open or closed refers to the state of an electrical circuit. When a lamp is turned on electricity flows through wires, the switch and the lamp; and the circuit is considered closed. When a lamp is switched off the circuit is considered open (or broken) and the flow of electric current is stopped.
The formula you are looking for is E = W/I.
To limit the current through the lamp when the gas ionises and conducts.
Parallel Parallel
The formula you are looking for is R = E/I. Resistance is stated in ohms.
White light from a Tungsten filiment lamp is best. If you shine a small ray of the white light in one end a rainbow ray should come out the other.