In the US, if you only have a black wire (ungrounded or hot conductor) and a white wire (normally a grounded conductor or neutral) there is not a ground wire. Sometimes the white wire is used as a hot, so each wire would have to be identified.
<<<< Electrical work should only be done by a qualified electrician.>>>>
white
Another AnswerIn US home wiring, red and black wires are typically "hot" or switch legs and white is "common" or the center tap of the supply transformer. In US homes, ground is either green or bare.In North America any coloured wire except white and green can be designated to be a "hot" wire. White is reserved for the neutral wire of a circuit and green is reserved for the ground wire in a circuit.
Red is hot Green is ground White is neutral
If this is a home wiring question and the wires are black and white then black is Hot and white is Neutral. If you also have a red wire, it is the other hot wire, and either the black or the red wire to the white one would be 120 volts, and red to black would be 240 volts.
In residential wiring the white wire is neutral on the 120 volt circuits. On a 3way circuit the red is the traveler and the white is neutral. On a 240 volt 3 wire connection the white & black are hot. On a 240 volt 4 wire connection the black and red are hot and the white is neutral.
Load (or hot wire, usually black or red), Neutral, (white), and ground,(green) wire.
Assuming the wires are the correct gauge for application and breaker you use black and white wires as hot. Put red electrical tape on each end of white wire and connect red and black to the breaker output and bare wire to ground lug in panel. At receptacle connect black and red to hot contacts and bare wire to ground lug.
Red is hot Green is ground White is neutral
normally the blue and red wires are hot white is standaed for nutral,
If this is a home wiring question and the wires are black and white then black is Hot and white is Neutral. If you also have a red wire, it is the other hot wire, and either the black or the red wire to the white one would be 120 volts, and red to black would be 240 volts.
No, there are different occasions when the red of a three wire cable gets used as a hot wire. There also times when the white wire gets used as a hot but has to be re identified as a hot with marking tape. When wiring baseboard heaters the cable used is red and black with no white wire in the set.
In residential wiring the white wire is neutral on the 120 volt circuits. On a 3way circuit the red is the traveler and the white is neutral. On a 240 volt 3 wire connection the white & black are hot. On a 240 volt 4 wire connection the black and red are hot and the white is neutral.
You have a 3 way switch. Your black wire is the hot wire. Your green wire is the ground wire. Your red and white wires go to the light and other switch. You should have gotten a wiring diagram with your switch.
If the home was wired properly the black or red wire are hot the white is neutral and the green is ALWAYS the ground
Where there is a red wire involved that usually indicates some type of special switching arrangement or more likely a 240 Volt circuit. In this case there will be 240 volts across the red and black and they will both be hot. Normally for 120 Volts the black is hot, the white is common and the bare wire is ground.
The red wire is the hot wire. The black wire is the ground wire. The green wire is the speaker wire. The white wire is the auxiliary wire.
If wired correctly the red wire will be hot, but any wire can be hot regardless of colour if done incorrectly.
Yes, in most cases it is the white wire. (the black or red wire is the hot and the bare wire is the ground.)
Black Wire from photocel to hot wire(black) coming in red wire to light fixtures black wire. White wire to neutral wires all light and power source white.