No, there are different occasions when the red of a three wire cable gets used as a hot wire. There also times when the white wire gets used as a hot but has to be re identified as a hot with marking tape. When wiring baseboard heaters the cable used is red and black with no white wire in the set.
In household wiring the black or red is active, live, or hot.
The white is neutral. The house does have a neutral wire even though it may be black. One of those black wires is the neutral and the other is the hot wire. You will have to determine which is hot and which is neutral. You can easily do this with a voltage tester. The wire that lights the tester is the hot. When you wire the light simply wire the hot to hot, and the white and green to the other wire.
You have a 3 way switch. Your black wire is the hot wire. Your green wire is the ground wire. Your red and white wires go to the light and other switch. You should have gotten a wiring diagram with your switch.
Positive is a term that is associated with DC current and has nothing to do with house wiring unless it is run off of an inverter.
If you live in Europe, then the brown wire is the line ('hot') conductor; a blue wire is the neutral conductor, and a yellow/green striped wire is the protective (earth) conductor.
That depends if it is automotive or household wiring. On a car a black wire is almost always ground. On house wiring black is the supply (hot) wire.That depends if it is automotive or household wiring. On a car a black wire is almost always ground. On house wiring black is the supply (hot) wire.
In household wiring it is the "hot" wire that carries current to the load.
In house wiring you have hot (Black), neutral (White) and ground (Bare wire).
In household wiring the black or red is active, live, or hot.
If this is a home wiring question and the wires are black and white then black is Hot and white is Neutral. If you also have a red wire, it is the other hot wire, and either the black or the red wire to the white one would be 120 volts, and red to black would be 240 volts.
The white is neutral. The house does have a neutral wire even though it may be black. One of those black wires is the neutral and the other is the hot wire. You will have to determine which is hot and which is neutral. You can easily do this with a voltage tester. The wire that lights the tester is the hot. When you wire the light simply wire the hot to hot, and the white and green to the other wire.
Black Wire from photocel to hot wire(black) coming in red wire to light fixtures black wire. White wire to neutral wires all light and power source white.
You have a 3 way switch. Your black wire is the hot wire. Your green wire is the ground wire. Your red and white wires go to the light and other switch. You should have gotten a wiring diagram with your switch.
Positive is a term that is associated with DC current and has nothing to do with house wiring unless it is run off of an inverter.
It is most likely a wire that was left there after the pre wiring of the house, for a connection to a garbarator if the homeowner installed one.
If you live in Europe, then the brown wire is the line ('hot') conductor; a blue wire is the neutral conductor, and a yellow/green striped wire is the protective (earth) conductor.
If it is in a house generally black wires are hot and white wires are neutral (common). The neutral and ground wires are tied together in the main panel. With that said if you put 1 lead of your meter (set on AC voltage) on a black wire and the other lead to ground and you get 120 vac that wire is hot. If you get no reading it could be classified as common. This is the normal wiring practice. This is a basic assumption without having 1st hand knowledge of the wiring system If in doubt contact a qualified electrician