In household wiring the black or red is active, live, or hot.
If the home was wired properly the black or red wire are hot the white is neutral and the green is ALWAYS the ground
By "clear insulation," I assume you mean the type of wire used in some lamp cords. If so, the hot wire is the one with the smooth (non-ribbed) insulation.
The black wire is the hot wire through which the electrical current flows to the appliance. The left over voltage which is usually zero flows back to the main circuit panel through the white neutral wire where it flows to ground.
An electrical circuit forms a loop. The "live" or hot wire supplies the voltage, which is returned on the neutral. If the hot wire and neutral wire were connected together without a load between them, the circuit would be short out and trip the circuit's protection device.
No, the wide prong is neutral it is the white wire. The narrow prong is hot it is the black wire. The round prong (in a 3 wire plug) is safety ground it is the green wire.
The electrical terminology of a wire with no insulation on it is a bare wire.
the hot wire carries the electrical voltage
If a "hot" wire contacts the "neutral" or ground wire, electrical current flows to the ground.
If the home was wired properly the black or red wire are hot the white is neutral and the green is ALWAYS the ground
One can purchase a hot wire cutter through various stores that sell electrical appliances. There are equally some online stores that sell hot wire cutter like, amazon.
By "clear insulation," I assume you mean the type of wire used in some lamp cords. If so, the hot wire is the one with the smooth (non-ribbed) insulation.
The "hot" wire between these two coloured wires will be the blue one. The green colour is always used as ground in electrical circuits.
You hooked the ground wire to you amp to a hot wire. The hot wire is black and it's the hot wire to the cigarette lighter. I used to be a Ford mechanic and saw this alot and charged people lots of money to fix their Stupid mistake.
The black wire is the hot wire through which the electrical current flows to the appliance. The left over voltage which is usually zero flows back to the main circuit panel through the white neutral wire where it flows to ground.
An electrical circuit forms a loop. The "live" or hot wire supplies the voltage, which is returned on the neutral. If the hot wire and neutral wire were connected together without a load between them, the circuit would be short out and trip the circuit's protection device.
No, the wide prong is neutral it is the white wire. The narrow prong is hot it is the black wire. The round prong (in a 3 wire plug) is safety ground it is the green wire.
In most circumstances and electrical schematics L1 is black and L2 is white. L1 is usually the "hot" wire and L2 is the "neutral".