0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Can you connect a 6mm earth wire to a 2.5 mm earth wire?
A 6 mm earth wire can be used to replace a 2.5 mm earth wire, but if there is an existing 6 mm earth wire it must be 6 mm all the way to the earth, and not replaced by a smaller wire between it and the earth connection.
Why is wire sized in sq mm?
It is metric that is used in the European standard of wire measurement.
How many amps will taken in sq mm copper wire?
10 amps
Does a wire with a diameter of 0.01 mm have lower resistance than a wire with 0.1 mm?
No, a smaller diameter wire has a higher resistance. The 0.01 mm wire will have 1/100 the cross-sectional area of the 0.1 mm diameter wire, therefore the resistance will be 100 times as high.
What size of wire should you used to 10 amp load?
2.5 squre mm
What is 14SWG copper wire in mm?
1.628 mm
What size wire dose a ground fault breaker use?
2.5 sq mm or 4.Sq mm coil is used for breaker in industries
Where is horn switch in 98 zx2?
The center of the steering wheel comes off by removing two 10 MM bolts of each side on the back of the steering wheel, facing toward the column. The switch is integrated into the air bag assembly. The red wire goes to the switch and down the column. If, when you press the horn, you hear a click, the switch is okay. There may be another problem with the relay or horn. I found that the horn itself it above the bumper behind the headlight on the passenger side of the car. You might check it also.
How do you wire up a starter on a 1994 Chevy Cavalier?
This car uses the permenant magnet light weight front drive GM starter. It has a main battery cable and a swith wire conected to it. 15 mm and 8 mm usually depending on what rebuilder had it apart.
How big is the stink horn mushroom?
90 to 110 MM
What wire do you need to run 7KW?
8square mm wire by youthbala
How thick is 26 gauge steel in mm?
For a wire classified under American Wire Gauge standards, 26 gauge wire is 0.0159" (0.40386 mm) in dameter. For a wire classified undere metric wire gauge standards, a 26 gauge wire is 2.6mm in diameter. Metric gauges are calculated simply by multiplying the diameter, in mm, by 10 and therefore increase as the diameter increases, unlike the AWG standard.
