answersLogoWhite

0

Add your answer:

Earn +20 pts
Q: What would be the first change to occur to a bar magnet if you were to place it in a laboratory furnace capable of melting any mineral and turned the thermostat to the maximum?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the maximum allowable limit of CO in the flu gas furnace?

400 ppm of air free


What does the thermostat control?

The engine thermostat controls the flow of coolant to the radiator , it allows the engine to warm up before the thermostat opens in order to limit the maximum operating temperature.


What is the maximum amperage usually encountered by a low-voltage thermostat?

2 amps


What is the maximum amperage usually encountered by a low voltage thermostat?

2 amps


What is the Clinical and Laboratory Standards Institute recommended maximum depth of heel puncture?

2.0mm


Does The capacity of a stream measures the maximum size of particles it is capable of transporting?

FALSE


The capacity of a stream measures the maximum size of particles it is capable of transporting?

FALSE


What temperature does wood scorch?

Inside a boiler furnace the maximum temperature could go upto 700 deg c.


What is the maximum frequency and minimum amplitude that can be measured with the CRO available in laboratory?

Type your answer here... 450000 hz


How much fuel can a Concorde carry?

The Concorde was capable of carrying a maximum of 210,940 pounds of fuel.


Why is it more important to have a constriction in a clinical thermometer than in a laboratory?

It stays at the maximum point so you get an accurate reading


How do you know if your geyser thermostat is not working?

Disconnect power to geyser and remove the thermostat. Turn heat selector to maximum and with the thermostat removed from the geyser and electrical wiring, test for continuity between the input and output sides of the (L)ive side. If there is continuity the thermostat is ok and the fault may then lie with the element.