answersLogoWhite

0

I have a 1996 D R and have the same problem. Apparently the flasher switch needs to be replaced.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Why are your blinkers not working on your 1993 Chevy 1500?

Most likely you have a flasher that needs to be replaced.


How do you fix a car blinker that is not working but the hazards are working fine?

Check/change the fuse associated with the blinkers.


1991 Toyota corolla front blinkers and hazards not working but my back blinkers and hazards are working all other lights are good and working my fuses are good?

Change front light bulbs


Blinkers stopped working?

Replace the Turn Signal Flasher Relay.


Why is your blinkers and hazards not working?

It may be a bad fuse.... Try that.


The blinkers in my 1977 Ford F-250 stoped working why?

try replacing the flasher unit for the blinkers its a 3 dollar part


2000 buick lesabre blinkers not working?

Blown fuse/? blown bulbs /?bad flasher.


1998 Ford Contour blinkers have stopped working changed flasher still not working what is the next step?

check your fuses


When i replaced my gauges in your 1991 Chevy camaro y did my blinkers stop working fuses under the dash are good are there more?

There is also a flasher unit that makes them flash, try replacing that unit.


Why your blinkers stop working on your 04 Monte Carlo?

you probably need a new turn signal flasher .


What causes the Blinkers to stopped working in a 2001 grand am?

There could be numerous problems that may cause this fault. Personally, my blinkers started going out (working sometimes and sometimes not) and what I found out is this...The flasher switch that is located in the dashboard above the radio is faulty. When my blinkers do not work i just tap down on the flasher switch without turning it on and my blinkers work again. Shotty electrical work in this car if ya ask me.


Why is your Blinkers Not Working on your 1991 Plymouth Sundance?

All Bulbs were replaced. fuses all checked, relay switch new and flasher, Also when the relay switch is in it gets really hot. Any suggestions