answersLogoWhite

0

Start at the fuel filter. It may be clogged.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What does your car do when you need a coil pack on a 1996 cavalier 2.4l?

The car will idle rough and hesitate during acceleration.


What causesm 98 Toyota Camry to stall during acceleration?

A bad fuel line can cause a 98 Toyota Camry to stall during acceleration. This happens when the line can not get proper fuel to the engine.


What causes a 1995 Buick Lesabre to hesitate during acceleration?

A bad o2 sensor can cause this problem in a car. A bad fuel pump, fuel filter or fuel line will also cause hesitation during acceleration.


What would cause a 2004 mercury sable hesitate and jerk during acceleration?

Replace the spark plugs and wires. Replace the fuel filter.


My Toyota Previa as a wineing noise when you accelerate and is getting worse?

Previas have a history of a whining noise coming from the catalytic converter. There is a bracket inside the converter that when loose or has came apart creates the whining noise during acceleration. It especially is very pronouced during high speeds in the freeway. You might be in for an expensive cat converter replacement.


How can you know when you fuel pump going bad in a Toyota Previa 92?

You can suspect a failing fuel pump in a 1992 Toyota Previa if you experience difficulty starting the engine, frequent stalling, or a noticeable drop in power during acceleration. Additionally, you might hear unusual noises from the fuel tank, such as whining or buzzing, when the ignition is turned on. Checking the fuel pressure with a gauge can also help determine if the pump is functioning properly. If the pressure is lower than the manufacturer's specifications, it may indicate a failing fuel pump.


Can an offset distributor cap cause jerking during acceleration?

Yes, an offset distributor cap can cause jerking during acceleration. If the cap is misaligned or has worn contacts, it can lead to inconsistent spark delivery to the engine's cylinders. This inconsistency can result in misfires, causing the engine to jerk or hesitate during acceleration. Regular maintenance and inspection of the distributor cap can help prevent such issues.


Where is the location of engine mount for Toyota Previa?

The engine mount for the Toyota Previa is typically located on the front of the engine, near the transmission. It helps secure the engine in place and absorbs vibrations during operation. There may also be additional mounts on the sides or rear of the engine, depending on the specific model year and configuration. Always refer to the vehicle's service manual for precise details.


How much gas does a 1991 Toyota Previa get?

A 1991 Toyota Previa typically gets around 18 to 22 miles per gallon (mpg) in the city and about 22 to 25 mpg on the highway, depending on factors such as driving conditions and maintenance. Its fuel efficiency can vary based on the specific model and engine configuration. Overall, it's considered moderately efficient for its class during that time period.


What causes a crown Victoria to hesitate during acceleration?

Whats the year? Possible problems.........Spark plugs, ign. wires, fuel filter. injector's dirty, timing. Theres a few more, but start with this.


What would cause a 2004 Ford Taurus to hesitate and jerk during acceleration?

You must run the OBD codes to find out for sure, but sounds like a faulty ignition module or a plugged fuel filter


Where is the bleed nipple located on Toyota Previa 1998?

On a 1998 Toyota Previa, the bleed nipple is typically located on the brake calipers for the front and rear brakes. To access it, you will need to lift the vehicle and remove the wheel. The bleed nipple is usually a small threaded valve on the top of the brake caliper, which allows air to be expelled from the brake system during bleeding. Always ensure you refer to the vehicle's service manual for specific locations and procedures.