There is a switch down at the brake pedal, It's most likely bad.
This is true. There is a switch under the brake pedal that probably needs to be adjusted or replaced. I have this same problem in my 1998 Mercury Villager. I have not replaced or adjusted the switch...not sure the cost or how hard it is to do. However, I have found that once you are in park, if the brake lights do not go off, I press down hard on the brake pedal and the lights go off.
== ==
This is usually cause by a stuck brake light switch on the brake pedal. Replace it.
Either the brake light switch or on brake pedal there is a button that pushes the switch and it fell out.
I have a 98 Villager and I had the same problem. I found that the brake light switch at the brake pedal needed adjusting. Just loosen the lock nut and adjust the switch so that the brake lights do not stay on but only come on when the brakes are applied, then tighten the locknut. Worked for me. Hope this helps.
check the brake light switch behind the brake pedal under the dash.
a mis adjusted brake light switch could cause that fault.
There is a bushing that the brake light switch rest against when the brake pedal is not depressed. They are known to break. You can get a replacement bushing from any Honda dealer for around $5.00. Just tell them your brake lights stay on all the time and they will know what to give you.
The brake lights will stay on if the switch is either out of adjustment or damaged. Pull up on the brake pedal to see if it will go out, if it does, you might be able to get by just adjusting the position of the brake light switch. BTW, it's on the brake pedal mechanism, under the dashboard.
A malfunctioning brake light relay switch will cause your 1993 Toyota Corolla brake lights to stay on all the time. The brake light relay switch is located beneath the drivers side dashboard.
witch lights
Probably a brake light switch.
If the brake lights stay on when the car is not running on most vehicles, including the 1994 Dodge Intrepid, there is probably a short somewhere in the wiring to the brake lights. The first place to investigate this problem would be the wires along the firewall that control the brake lights. Also, check the brake light switch above the brake pedal.