A missing wire would cause an incomplete circuit.
A missing wire would cause an incomplete circuit.
The green wire is for ground. You can attach that to any metal part of the frame. The red is the active and coincides with the lefthand prong into the plug and the black in this case should be the Neutral and ciocides with the right prong into the plug as seen standing behind the plug.
you cut the yellow and black wire from the origanal plug and wire these from the CD player wire the yellow, red, blue, wire into the yellow and the black from origanal plug to black on CD player
No, the wide prong is neutral it is the white wire. The narrow prong is hot it is the black wire. The round prong (in a 3 wire plug) is safety ground it is the green wire.
The green or bare wire is typically the ground wire for a dryer plug. If your wires are black, white, and red, the white wire is usually neutral, the black is hot, and the red is also hot. You should double check with a voltage tester to be certain.
You would have a misfire and it may damage the coil if operated long enough in that condition.
The significance of the red, black, and green wires in a three-pin plug typically corresponds to their functionality. The red wire is usually the live wire, the black wire is the neutral wire, and the green wire is the earth wire. These colors help to identify and properly connect the wires for safe and correct electrical wiring.
If it is the same plug every time, I would say the plug or wire is grounding out some where. Try replacing the plug the the wire.
bad spark plug wire.
blue and black
Under the hood, on the passenger side. There is a 4 wire plug into the black housing. It is right there.Under the hood, on the passenger side. There is a 4 wire plug into the black housing. It is right there.
The black wire goes to the brass colored screw and the white wire goes to the silver screw.
You will have to check to make sure. Normally, with 4 wires, the black and red are both power for 220. White for neutral and bare for ground. If you are only using one leg of it, you would use the black, white, bare ones and cap the red one. Someone may have used the 4 strand because they had it or 220 was planned but not done or both the red and black are hot. You should be able to tell in the panel. Do the red and black both connect to separate breakers or to one or is the red not connected?