Some sort of agency marking or inventory control
If you mean a Smith & Wesson Model 629-1 revolver, it is stamped on the bottom of the grip frame. It will be covered by the grips. A secondary SN is usually stamped on the frame under the cylinder crane. Open the cylinder to see it.
Check gunpartscorp website, under H for Herbert Schmidt, and check under small frame. There are still SOME parts available for these.
The sn is located on the bottom of the butt. If it was made after model numbering started, it will also be located under the cylinder yolk on the frame.
it is on the front left side down next to the frame it is bolted to the frame. down under the master cylinder. it is down under the master cylinder on the front left side about halfway down the fender well
The brake master cylinder on a 1955 Pontiac is bolted to the frame rail under the steering shaft.
Under vehicle, inside frame rail, aprox under drivers area.
Open the cylinder- can be found stamped on the frame under the yoke.
on the frame rail, on the inside frame rail, drivers side, aprox under drivers seat.
AnswerThe proportioning valve and warning switch is integrated into the master cylinder assembly.I think the proportioning valve is located on the frame rail under the master cylinder?Thats where it is on my 1980.The proportioning valve is not on the frame rail on an 84. It is inside the master cylinder.
Look under vehicle along the frame follow the fuel line from the tank Look under vehicle along the frame follow the fuel line from the tank
If it's a four cylinder (2rz or 3rz) it will be under the intake manifold mounted to the engine block. If it's a 6 cylinder (5vz) it will be under the cab on the frame rail.
When you swing out the cylinder, it'll be visible on the frame under the piece that holds the barrel.