0
What else can I help you with?
If 3 1.5 V cells were connected in series what would the total voltage of the circuit be What about in Parallel?
4.5 volts in series; 1.5 volts in parallel.
What would be the voltage suplied to each circuit if three circuits are connected in parallel with a power supply of 30 volts?
30 volts.
What are four characteristics of parallel circuit?
an example would be thus. if you had say 2 1.5 volt batteries each say .006 amps. When these batteries are in series the positive end of one is in contact with negative end of the other, pretty much like a common flashlight, and the voltage would be 3 volts., .006 amps. When the same two batteries are connected negative to negative and positive to positive the voltage would still be 1.5 volts but the amperage would be .012 amps. (amps doubled when in parallel, voltage doubled when in series)
A circuit has an applied voltage of 100 volts and a resistance of 1000 ohms What is the current flow in the circuit?
A circuit has an applied voltage of 100 volts and a resistance of 1000 ohms. The current flow in the circuit is 100v/1000ohms which would equal .1.
What will be the voltage across two parallel conneted batteries of 10 volts and 5 volts?
15 voltsThe result would only be 15 volts if they were connected in series. If in parallel, a 10v and a 5v battery would probably come out with a voltage of either 10 volts or 7.5 volts, there's no way to tell for sure though.
Who lights brighter bulb in a parallel circuit?
Yes, since each light would get the full voltage. Be careful if you actually carry out this experiment, that the lights don't get too much voltage. If the voltage is (for example) 110 Volts, and the lights are built for 110 Volts, you would have no problem; in a series circuit they would simply get dimmer.because the wires are togetherAnswerNot necessarily. It depends upon the voltage ratings of the lamps, and whether the voltage across each lamp matches their voltage rating.
Which circuit would have the highest voltage series or parellel?
In a series circuit, the voltage is divided among the components, so the highest voltage is at the beginning of the circuit. In a parallel circuit, each component receives the full voltage of the source, so the voltage is the same across all components. Therefore, the circuit with the highest voltage would be in a series circuit.
Why you can't usually swap bulbs between series and parallel sets of lights?
If it is in the same circuit, the voltage would not be the same. ANSWER: That is possible if both bulbs have the same rating of volts and amperes
Which type of circuit a series circuit or a parallel circuit would allow the light bulbs to burn brighter?
In a parallel circuit, each light bulb would receive the full voltage of the power source, allowing them to burn brighter compared to a series circuit where the voltage is divided among the bulbs.
How do you wire 6 batteries?
Depends on if you want a series or parallel circuit. In a series circuit if you wire six 12 volt batteries together you will end up with 72 volts. Wire the same six 12 volt batteries together in parallel and you will still have 12 volts. In a parallel circuit you just wire all positive posts together and all negative posts together. In a series circuit you would wire positive to negative to increase the voltage with each battery added.
How do you use volts?
Volts are used to measure the electrical potential difference or voltage in a circuit. To use volts, you would typically measure the voltage across a component in a circuit using a multimeter or voltmeter. This helps in determining if the component is receiving the correct amount of voltage for proper operation.
Why would houses have parallel circuits?
So that the voltage across all devices is the same. In a series circuit voltage would vary across each load so would depend on what else was in the circuit.
