All of them. Some were carburated, some fuel injected. Just pick the right one.
the manifolds should be the same for the 350and 305. be careful, however about the year of your manifold, older manifolds have the four center holes drilled at the same angle as the heads and the rest of the holes, newer manifolds have the four holes drilled straight up and down, and the two are not interchangeable
No. There were major engine changes between those years.
intake manifold is DIFFERENT for models 1985 and 1988
The connector into the intake manifold of a GM 305 and 350 has been known to be quite fragile. If the connector has broken you have little choice but to replace the manifold.
It will as long as the 305 is a VORTEC ENGINE TOO.
yes, direct bolt-in. Might be necessary to transfer peripherals from the original engine such as intake manifold, exhaust manifolds, ignition system, front pulleys, oil pan.
Yes it did.
PROPER TIMIMNG SHOULD BE LISTED ON THE INTAKE MANIFOLD PROPER TIMIMNG SHOULD BE LISTED ON THE INTAKE MANIFOLD PROPER TIMIMNG SHOULD BE LISTED ON THE INTAKE MANIFOLD
It is an intake off of a late sixtys small mblock chevy. 350cid or 305 cid
yes
take all the wiring and hoses loose from the top of the engine, and you might have to remove the valve covers. then just loosen the intake manifold bolts
yes it will fit, 262-400ci chevy smallblock manifolds are interchangeable.