Is the B18C head Compatable with the B20 Block
The b20 will smoke the b18
Yes.
You have to acquire a vtec head either from a b16 or a b18 (gsr)
a b16 vtec head on a b20 bottom end is the way to go good hp and massive torque also known as a frank motor
you can use the same exact transmission for both engines. they mount up direct and will not cause any problems. the B18 and B20 engines are a direct swap for the most part, just plug and play. but basically if you have the B18B ecu and b18b tranny, intake manifold, distributer and so on.. you can swap everything over
Manifold absolute pressure sensor, being hondas run of calculations to adjust fuel to air ratio (called speed density) they require this to calculate amount of fuel to use. This is on top of the manifold dependant upon year b18 head, Da's had sensors located on firewall. B20's have the exact same head cast and cams as a b18b head. unless your refering to a vtec head there is no difference.
The B20 motor comes from the Honda CRV. Answer The B20 engine is a Japanese engine used in the Acura Integra. They might use a different head but I know that block is the same. I believe that it's the B18 and all they did was remove cylinder sleeves to bore it out to a 2.0 I would have liked to put this engine in my 1991 Honda Civic Si Hatchback when I had it.
a b16 b20 b18 all the d models should fit right in
Any formula can use B20. There is no limit. Here are some: =B20+10 =B20*4 =SUM(B20:B45) =B20/100
A1 to B20
91 acura integra has a b18 91 acura integra has a b18
One may find more information about B18 from Wikipedia. The B18 is filed under Honda B Engines. A full history and engine specifications are provided.