answersLogoWhite

0

What else can I help you with?

Related Questions

Some task that can be done with the Linux conf tool?

what are some of the tasks that can be done with the lunax conf tool?.


What does the GTW tool mark stamped on older axes stand for?

Germantown Tool Works


What was the fist tool to find gold?

ther are to tools that had found gold first witch is a shifter and a shavol


How do you set injection timing on 99 dakota 3.9 motor?

A scan tool is required. The distributor is "zeroed" with the aid of the scan tool. This can not be done with a timing light.A scan tool is required. The distributor is "zeroed" with the aid of the scan tool. This can not be done with a timing light.


How do check ac codes on 87 mark vii?

To check the AC codes on a 1987 Lincoln Mark VII, you'll typically need to use a diagnostic tool like a scan tool that can read the vehicle's onboard diagnostics (OBD). First, locate the diagnostic connector, usually found under the dash near the steering column. Once connected, follow the tool's instructions to retrieve any trouble codes related to the AC system. If you don’t have a scan tool, you might consult the service manual for specific procedures to access AC codes via the vehicle’s self-diagnostic capabilities.


How do you disable the computer to set the timing on a 1997 dodge ram 5.9?

It doesn't work that way. You set initial distributor timing by lining up the crank at tdc and the rotor with the mark on the pickup plate. The next step requires a scan tool and can not be done with a timing light. Using the scan tool, the distributor is set to be in sync with the crank position sensor.It doesn't work that way. You set initial distributor timing by lining up the crank at tdc and the rotor with the mark on the pickup plate. The next step requires a scan tool and can not be done with a timing light. Using the scan tool, the distributor is set to be in sync with the crank position sensor.


What is the paragraph formatting mark in word called?

format tool


How do you set the ignition timing on a 1993 dodge 3.9 v6?

Initial timing is set by lining the rotor up with the mark on the pickup plate in the distributor with the crankshaft at #1 top dead center. The timing is then fine tuned to 0 degrees with a scan tool. It can not be done with a timing light.Initial timing is set by lining the rotor up with the mark on the pickup plate in the distributor with the crankshaft at #1 top dead center. The timing is then fine tuned to 0 degrees with a scan tool. It can not be done with a timing light.


What tool is used to mark lines on metal?

there are many tools to mark metals with. Common tools to mark metals with include chalk and soapstones


What is the timing on a 5.9 magnum?

The distributor is set to 0 degrees with a scan tool. It can not be done with a timing light.The distributor is set to 0 degrees with a scan tool. It can not be done with a timing light.


How do you reset your 1997 Jeep Grand Cherokee distributor?

The timing is set with the aid of a scan tool. It can not be done with a timing light.The timing is set with the aid of a scan tool. It can not be done with a timing light.


How do you set the ignition timing on a 1999 dodge ram 360?

It is set to 0 deg. with a scan tool. It can not be done with a timing light.It is set to 0 deg. with a scan tool. It can not be done with a timing light.