Want this question answered?
it depends on what type of load. Motor amperage will drop off as voltage rises. loads such as lights will increase amperage with voltage rise.
An ammeter measures amperage not voltage.
Ohms Law says Voltage = Current x Resistance. Hence if voltage rises, so will current.
Power (P) = Voltage (V) x Amperage (I) Written as P=VxI or to find Voltage V=P/I Voltage is measured in Volts (V) Amperage is measured in Amperes (Amps or A) Power is measured in Watts (W)
A step up transformer converts low voltage,high amperage current to a high voltage,low amperage current. It requires large diameter wire to carry the high amperage in the primary coil.
This doesn't make sense, "current" is "amperage" so the higher the voltage the lower the amperage, and the lower the voltage the higher the amperage.
The relation between amperage and capacitance is that amperage is equals to capacitance times the rate of voltage change over time. This voltage refers to instantaneous voltage.
Voltage is equal to amperage time resistance. V=IR Therefore, I'd say voltage times amperage is equal to amperage squared times resistance. VI=IIR Really there's no point in multiplying the two. However, if you were to divide voltage by amperage, you would have the resistance of the circuit. V/I=R
it depends on what type of load. Motor amperage will drop off as voltage rises. loads such as lights will increase amperage with voltage rise.
Depends on the voltage and amperage of the battery vs. the voltage and amperage required of the bicycle.
An ammeter measures amperage not voltage.
With kitchen tongs. A mild tingling indicates low voltage/low amperage. Muscular spasms indicate high voltage/low amperage. Unconsciousness sans death indicates low voltage/moderate amperage. Death indicates high amperage. Good luck.
Ohms Law says Voltage = Current x Resistance. Hence if voltage rises, so will current.
Generally speaking an appliance (eg tv) is supplied with power so when it is off it has voltage supplied. After yo turn it on it starts to draw power called amperage the voltage doesn't get higheur but the amperage does Amperage is the load being drawn through a circiut
A device for measuring voltage, amperage and current.
Power (P) = Voltage (V) x Amperage (I) Written as P=VxI or to find Voltage V=P/I Voltage is measured in Volts (V) Amperage is measured in Amperes (Amps or A) Power is measured in Watts (W)
Wire size is based on the amperage drawn. To find the amperage, the voltage must be stated. Use this formula to find the amperage. I = W/E. Amps = Watts/ Volts. Once you have the amperage, restate your question using the new found amperage or state the voltage that supplies the lights.