answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: When carrying out an Insulation test on a Class 2 appliance the reading is taken between which points?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Between what values should the safe reading of insulation resistance of a domestic house?

Between .5 meg ohms to 2 meg ohms is a safe range for your house wiring insulation. Infinity is the ultimate.


What is the maximum insulation resistance reading on a 800A busbar?

infinite


How do I know I can trust a reconditioned appliance?

The best way to know if you can trust a reconditioned appliance is to inspect it thouroughly. Reading reviews of the company providing the appliance can also help you choose a trusted provider.


Can you plug 120 volt appliances into 127 volt outlet?

because your appliance is connected to the L1(secondary coil1) and your meter reading voltage is on the other coil (secondary2) It is called Mutual Induction ! Between the 2 coils on the secondary side of TRANSFORMER I wish i could draw it out


Why meter clocking need to be performed for any new piping installation?

To get an actual reading of fixture /appliance demand


What is dielectric absorption ratio?

This is a test usually used when performing a insulation resistance on a transformer. This test (result) can be optained by deviding the 30 sec reading into the 60 sec reading. This test recognizes the fact that "good" insulation will show a gradually increasing IR after the test voltage is applied.


What is a Current Reversing Transformer?

This is a transformer built into electrical appliance to make electricity meter to stop reading or made to read in reverse order. This reduces the consumption reading and cheats the system. That is bad.


Is there a spray on insulation made for bare copper wire?

Not that I know of. When insulation is applied to wire it is extruded so that the insulating material is uniform around the conductor. Without this uniformity the conductors insulation factor would vary and the wire would have to be rated at the lowest reading factor when tested with a high voltage. Even when splicing a wire, the electrical code states that the insulation covering the splice has to be brought up to or surpass the insulation factor that is supplied by the manufacturer of the wire.


Why insulation meter of LT panel shows low insulation reading below 500k ohm?

The only reason this would show is that the circuit has leakage to ground. This is still well above tripping current but the potential is there to advance into a short circuit.


What is the distance between Reading and London City?

The distance between London and Reading is 38 miles


How do you use individuals care plan while providing support?

By reading and carrying out the instructions within the care plan.


What are the answers to mission to mars reading plus level j?

Where is the shuttle carrying Roy and Ciara going?