answersLogoWhite

0

do not rotate crankshaft

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

What is the plastigage reading for a big block Chevy?

On the main bearings, .001, to .003.


How do you tell if main thrust bearing is bad?

You can tell if the main thrust bearing is bad by simply checking out the oil. If you notice little metal particles, chances are the thrust bearing has spoiled.


What is the main bearing spec for a Detroit diesel engine?

main bearing whats happens when goin out


How can you measure bearing?

It depends on the type of bearing, and which measurement. A double race roller bearing is measured on the inside (shaft diameter) with an internal vernier caliper or similar device. On the outside (casing or pillow block diameter) with an external vernier. And the width (or length) of each race can be measured with and external vernier. A babbitt bearing can be measured by measuring the journal on which it is to be mounted, then taking "leads" (or using plastigages), by placing lead fuse wire or a plastigage on the journal, placing the bearing top half over the leads, and bolting down the bearing housing over that. Then unbolt the bearing housing remove the top half the bearing and with a micrometer measure the crushed thickness of the fuse wire. Add this to the journal diameter to get the internal diameter of the bearing. The main reason for taking leads is to determine the oil wedge gap in the bearing to see if it is the right thickness. If it is too thin the bearing needs to be scraped if it is too thick the bearing needs to be replaced or the journal built back up to the correct diameter.


What are the Torque specs 1977 mercruiser 4-cylinder Chevy rod bearing and main bearing?

The rod bearing torque spec from mercruiser is 45 lb there is no spec that i can find for the main bearing caps.


2000 ford 300 6 cylinder rear main seal change do i need to remove main bearing cap?

You should not need to remove the main bearing cap, in order to replace the rear main seal. The rear main seal will come off without touching the main bearing cap.


What are the torque setting of the main bearing caps and rod bearing caps on a Toyota 2C Engine bolt main block?

the torque setting for the the main bearings of the Toyota 2c engine is 103 Nm. The rid bearing caps are 59 Nm


What is the torque spesifications of the main bearing cup pistion bearing cups and the cylinder head bolts of a 1kz 3 liter engine in a landcruser?

what is the torque specifications of the main bearing cup pistion bearing cup and cylinder head bolt tighteness


What is the rod bearing and main bearing torque on a 1991 Toyota Tercel 3E motor?

rod bearing Toyota tercel 87


Is the rear bearing on a 2003 silverado 1500 a pressed bearing?

Don't understand your question...... If you mean the rear main bearing in the engine ... then NO.


Show where thrust bearing is located?

The thrust bearing is located in the crankshaft journal. usually in the center main cap. Although sometimes toward the front or rear it is recognizable, the only main bearing with sides.


Putzmisiter rotating bearing for main boom column pump 43m?

we are looking for putzmisiter rotating bearing for main boom colum pump 43m