0
What else can I help you with?
If you have a bad compressor does that mean you need a new contactor?
Not always. But if a compressor goes bad it can take out the contactor. I have replaced compressors before and found the contactor is still ok. In a commercial application Copeland will not honor the warranty if the contactor is not replaced at the same time a new compressor is installed. Not sure about residential but for a $15 contactor I would not gamble with it.
What are the common signs of a bad AC contactor and how can it be diagnosed and replaced?
Common signs of a bad AC contactor include the air conditioner not turning on or off properly, frequent cycling, or a humming noise. To diagnose a bad contactor, visually inspect it for signs of burning or wear, and use a multimeter to test for continuity. If the contactor is faulty, it can be replaced by disconnecting power, removing the old contactor, installing a new one, and reconnecting the wires.
How do you test a good and working contactor?
A contactor is tested by using a device called a Multimeter. By setting the multimeter to ohms and rx1 you can clip both prongs to the coil. If the multinmeter moves the contactor is good. If it doesnt move its bad.
What is wrong when you have to hold the contacts down in order to get the outside rheem heat pump to come on and stay running?
low voltage from thermostat is not properly connected to contactor. transformer is bad. contactor is bad. >>>>>>>>>>>> You have an open pressure safety switch on the outdoor unit or the control wiring from indoors to outdoors is too small a gauge which will lower your control voltage at the contactor.
How does magnetic contactor operate?
explain me about the contactor works with examples. if i want to control a motor with contactor. and how i can use contactor in loops with over load and circuit breakers.
How do you calculate contactor capacity of star contactor?
metres
What is the difference between an definite purpose contactor and a lighting sontactor?
A definite purpose contactor is designed (and rated) for a specific load. So a lighting contactor is one example of a definite purpose contactor. A motor starter contactor is another example. So, a lighting contactor is a definite purpose contactor, but a definite purpose contactor is not necessarily a lighting contactor (it might be a motor starter, for instance).
Why does the air conditioner not shut off but the blower motor does?
compressor contactor is bad. probably stuck in the closed position.
Can you use an AC contactor in the place of DC contactor?
No, you definitely cannot.
Can you replace a 50 amp contactor with a 40 amp contactor?
Replacing a 50 amp contactor with a 40 amp contactor is not advisable, as the 40 amp contactor may not be able to handle the load safely. This could lead to overheating, failure of the contactor, or potential damage to the connected equipment. It's essential to match the contactor's rating to the load requirements for safe and reliable operation. Always consult with a qualified electrician for such replacements.
Definition of coil in contactor?
The coil in a "Contactor" is essentially an electromagnetic coil that provides the driving force to close the contacts in a Contactor. When the "Coil" is energized by a lower control voltage usually from some type of controller such as a PLC, the Normally-Open contactor will close or in the oposite case, the Normally-Closed contactor will open.
Why isn't the fan on your outdoor AC unit coming on when you have the thermostat set to cool?
1. Bad fan motor 2. Bad fan capacitor 3. Contactor bad 4. No power to outdoor unit.
