answersLogoWhite

0

Commercial Pacific Cable Company ended in 1951.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

When did Southern Pacific Company end?

Southern Pacific Company ended in 1969.


When did Pacific Creosoting Company end?

Pacific Creosoting Company ended in 1993.


When did Pacific Lumber Company end?

Pacific Lumber Company ended in 1903.


When did Omaha Cable Tramway Company end?

Omaha Cable Tramway Company ended in 1896.


When did Southern Pacific Transportation Company end?

Southern Pacific Transportation Company ended in 1998.


Which cable diagram displays the end to end pinout for a crossover cable used with Cisco devices?

Cable C


What is straight cable connection?

All of the pins on one end of the cable connect to the same pin numbers on the other end of the cable, hence, the wire goes "straight through" from one end of the cable to the other.For example, pin 1 on one end of the cable is connected to pin 1 on the other end of the cable, etc.


Is the Atlantic end of the panama canal west of the pacific end?

No, the Atlantic end of the Panama Canal is not west of the Pacific end; it is actually east of it. The canal runs from the Atlantic Ocean at Colón to the Pacific Ocean at Balboa, making the Pacific end the western terminus.


How do you properly install brake cable end crimps on a bicycle brake cable?

To properly install brake cable end crimps on a bicycle brake cable, follow these steps: Cut the cable to the desired length using cable cutters. Slide the crimp onto the end of the cable. Use a cable cutter or pliers to crimp the end of the cable securely. Make sure the crimp is tight and secure to prevent fraying of the cable.


What is a cable gland?

A cable gland is a connector which holds the end of a cable in place.


What is the proper way to replace a brake cable end on a bicycle?

To replace a brake cable end on a bicycle, first, loosen the brake cable at the brake caliper. Then, remove the old cable end by cutting it off. Next, thread the new cable end onto the brake cable and crimp it securely in place. Finally, reattach the brake cable to the brake caliper and adjust the tension as needed.


What is the name of the device that should be attached at the end of a cable in a cable topology?

its called a cable