It doesn't save any cost but it saves headaches if adjustment is necessary
covered outside learning area Or: Cost Of Living Adjustment (As in "you ain't gettin' one.")
it is used as fine adjustment to increase resolution of microscope
I assume you would use the fine adjustment knob for high power objectives.
I'm not sure if I understand the question. When using a compound microscope, you always want to start by adjusting the coarse adjustment under low power (like 4x) until you have whatever you are looking at in focus. Then, without moving the adjustment, go to the next power (like 10x or something) and use the coarse adjustment only a little and then use the fine adjustment to get it into focus again. Without touching anything, switch to the next power (say 40x) and DO NOT TOUCH THE COARSE ADJUSTMENT. You will lose your object and have to start all over. Only use the fine adjustment past this point. Again, focus as best as you can. This will depend on the microscope, but some also have a 100x power objective lens. It is best to put a drop of immersion oil onto your sample while you move from 40x to 100x. Then you should only use the fine adjustment a small amount to get your sample into focus. The immersion oil improves the resolution of the image that hits your eye, making it easier to see and not blurry.
You use the fine adjustment to focus in HIGH power with a compound microscpe.
For low power you can use the coarse adjustment and fine adjustment for high power you should only use the fine adjustment because on high power, the objective lens is too close to the slide and using the coarse adjustment may scratch the objective lens.
COLA is the acronym for Cost Of Living Adjustment.
There was no cost of living adjustment (COLA) in 2010 or 2011; benefits will continue being paid at the same rate as in 2009.
Each power-up ranges in cost Prices start at 1000 points up to 2500
use the fine adjustment knob to get a better view of what you are looking at.For low power you can use the coarse adjustment and fine adjustmentfor high power you should only use the fine adjustment because on high power, the objective lens is too close to the slide and using the coarse adjustment may scratch the objective lens.
use the fine adjustment knob to get a better view of what you are looking at.For low power you can use the coarse adjustment and fine adjustmentfor high power you should only use the fine adjustment because on high power, the objective lens is too close to the slide and using the coarse adjustment may scratch the objective lens.