0
What else can I help you with?
What is diode reverse current?
the current which has negative value n passes through the diode is called as diode reverse current
What is electronic resister?
Electronics resistor are a basic passive element it oppose the flow of current . the opposition depend upon the value of that resistance high value resistance will only able to flow some few amount of current through them. but low value of resistance allow to flow large current through them.
What is the flow of electricity through a wire?
In electrical terms it is known as current and it is expressed in the value of amperage.
When does the current flowing through two different arms in a circuit carry same current?
With the same voltage and resistance the current will be the same value.
What happens when a switch in a current is opened?
current through the switch become 0.and switch become a high value resistor.
What happens when a switch a current is opened?
current through the switch become 0.and switch become a high value resistor.
2 resistors unequal value are in parallel. Would the power dissipated by the resistor with larger ohmic value be greater than the power dissipated by the resistor of lesser value?
No, because the power dissipated in a resistor is proportional to the square of the current through the resistor but only directly proportional to the resistance of the resistor (I^2 * R) and the current through the lower value resistor will be higher than the current through the higher value resistor, the lower value resistor will usually dissipate more power.
What happens if voltage is constant and current is varying when an scr triggers?
Even if the current is varying,as long as the current reaches the value required to trigger the SCR, it will snap into operation. The SCR will remain in operation until the current through it drops to a value below the holding current.
What is the current value of the SPX500USD index?
The current value of the SPX500USD index is approximately current value.
Why Ohmmeter can't read the resistance value when current flow through resistor?
An ohmmeter is a calibrated circuit that puts current through the resistor to measure its value. If something else is also putting current through the resistor that the meter doesn't know about, the meter calibration is disturbed and a false reading results. It may even damage the meter.
Why resistor provides bias condition to the circuit?
A specified amount of current is allowed to flow through the diode. if the current passing through the diode exceeds the specific value, the diode gets heated and is likely to be damaged. therefore in a biasing circuit a resistance R has been applied , which limits the current passing through the diode within a specific value.
Which is the dangerous current?
You can't really separate them. It's the current flowing through your body that does the damage, but the value of the current depends on the voltage across your body -the higher the voltage, the higher the resulting current.
