Hyundai Accent
Toyota 4Runner
Toyota RAV4
Timing Belts and Chains

When should the timing belt be changed on a 1996 Toyota RAV4?

252627

Top Answer
User Avatar
Wiki User
2006-12-10 02:54:01
2006-12-10 02:54:01

Between 60K & 90K miles

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

It appears that the 1996 Toyota Tacoma has a timing belt.

User Avatar

Instructions on replacing 1996 Toyota Tercel timing belt?

User Avatar

does my toyota townace 1996 2.0L have a timing belt or a timing chain?

User Avatar

The 1996 Toyota Tacoma does not have a timing chain. It has a timing belt. It will cost approximately $600 to change the timing belt.

User Avatar

the warning lights comes on indicating that the timing belt needs to be changed. even once the timing belt is changed, the warning light will stay on until is it reset.

User Avatar

On a 1996 Toyota Tacoma : The 2.4 and 2.7 litre four cylinder engines have a timing CHAIN The 3.4 litre V6 engine has a timing BELT

User Avatar

According to your owner's manual under normal conditions, you should change your timing belt at 100000 KM.

User Avatar

There should timing marks, or you can consult a repair manual (very cheap.)

User Avatar

It should be changed every 60,000 miles. I am not sure if it is an interference engine or not.

User Avatar

timing belts are usually changed every 100,000 miles and you should be go to go

User Avatar

I paid $1,200 about a year ago to have my timing belt and water pump changed.2.0.

User Avatar

you cannot adjust the ignition timing on this car. a manual will help if you need to set cam timing

User Avatar

The cost to change the timing belt on a 1996 Toyota Corolla ranges from $400 to $800. The actual cost varies greatly based on the location in which the repair is performed.

User Avatar

A 1996 Toyota Tacoma 4-cylinder is able to use 5w20 weight oil. When the oil is changed, the oil filter should be changed as well.

User Avatar

Both the 3.0 and the 3.3 should be changed at 105,000 miles because they have a timing BELT. While you're in there, it might not be a bad idea to replace the water pump.

User Avatar

Hello there If you have a 1996 Toyota tacoma,4 cylinders. THERE IS NO WAY to adjust the timing on this trucks,because it comes permanently configured,so you do not worry about adjust timing on your beautiful truck,so you have maybe another problem,or maybe you have to change the whole timing chain kit.

User Avatar

'96 Camry (both 4 & 6 cyl) have a timing belt, which should be checked and replace per the vehicle maintenance manual.

User Avatar

According to the Gates website ( they make timing belts etc. ) the 2.2 liter four cylinder in a 1996 Toyota Camry ( is NOT an interference engine )

User Avatar

60,000 miles except in Ca, Mass, & Ct. where it should be changed every 100,000 miles.

User Avatar

Timing belts normally changed every 60,000 miles but if just aquired the car best to get a new one on for peace of mind

User Avatar

location of Crankshaft Position sensor, 1996 Camry,

User Avatar

To align the cams in a 1996 Toyota Camry, first be sure the number one piston is at the top dead center position. After this is put into place, the lower timing cover and the crankshaft pulley should have a temporary notch that is lined up with the zero mark on the timing cover. A small hole in the crankshaft gear should be pointing straight up and lining up with a mark on the front cam bearing housing. There should be no slack in the timing belt, and the engine should then be rotated a few times by hand to make sure that the marks are still aligned.

User Avatar

The timing is not adjustable. The ECM controls the timing with information received from various sensors.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.