It depends on the construction of the motor. If the field winding is connected in series with the armaturewinding, the motor is like a universal motor and will probably operate normally. If the field winding is connected in parallel with the armature, the motor will not run, but will draw current, make noise and get hot.
As the motor is a three phase machine,it must be AC supply
16.32 volts
AC and DC supply sources we are given to motor so we are called double excited motor
AC generators (alternators) usually have a dc supply to the rotor coils, supplied through slip-rings with carbon brushes. Because the slip-rings can be made very smooth the life of the brushes is greatly extended when compared with brushes on the commutator of a dc motor or an ac commutator motor. Cars generate electrical power with a three-phase AC alternator, connected directly to the battery through rectifier diodes. The alternator voltage is controlled by the voltage regulator, which works by controlling the dc supply to the rotor.
You can't. A three-phase motor works on a completely different principle from a d.c. motor (e.g. there's no electrical connection to the rotor). As well as this, with a d.c. supply, you will only be able to connect one phase of the field windings, and the resistance of that field winding will be low compared with its reactance, and may well burn out if you connected it to a d.c. supply.
A dc series motor with speed control can be connected on ac supply because dc machines are totally reversible.
Through loda
opposes changes in current
Basically AC motors would not work on DC supply but there's however an exception for a Universal motor also known as a series motor. This is the only motor as far as I know that work on both AC and DC.
why does the lamp bright when it is connected to the AC supply
As the motor is a three phase machine,it must be AC supply
A transformer must be connected to an alternating current (AC) supply of the correct voltage.
The direction of the motor is dependent on the way the stator coils are wound.
Ac motor have slip ring, to remove the slip ring,connected to the commutator its a dc motor.
16.32 volts
the universel motor can runs at both ac and dc supply.
in 3 phase motor u1,v1,w1 give to the short terminal and remaining v2,u2,w2 give t0 the in coming power supply of 440v