Cut the Wire was created in 1987.
You Should Cut The Yellow Wire! : D
Just use some wire cutters or sharp scissors & cut (only until you feel wire)while you rotate around. Once you cut all the way around, pinch where you cut (carefully)with implement & pull off insulation. It takes a little practice,& occasionally you will go thru wire as well, but that's how it's done.
Phisical
you take the blue wire and connect it with the red then connect it to the yellow then you cut the green wire and there you go!
Hot wire Buck saw, but messy
You Should Cut The Yellow Wire! : D
you can cut any wire you choose to cut. i, however, would not cut it.
You cut carefully so that the wire does not touch the middle of the clay.
With a pair of wire snips.
Wire to Wire was created on 2008-10-27.
Cut the blue wire that goes into the actual motor
Cut all of the wires
To cut wire.
To strip wire, you can use a wire stripper tool by adjusting it to the appropriate gauge of the wire, then placing the wire inside the tool and squeezing the handles to cut through the insulation. Another method is to use a utility knife to carefully cut around the insulation and then pull it off. Always be careful not to cut into the actual wire while stripping.
Bird on the Wire was created in 1969-04.
You need to go to the bottom right place on the map in the vents. On your way you will find wire cutters. You cut the wires with the wire cutter.
Walking On a Wire was created in 2009.