Elderado Dingbatti was created in 1989.
Between 1540 and 1542.
1988 Cadillac Elderado Looking right at it
NO, they were made for 15 inch tires.
horn don't work a 1992 elderado, where is it or where is fuse panel for horn ?
inside light on dash will not go out when the ignition switch is off
yes you can. run a 22x9 or 22x9.5 with a mid to low off set 0-10mm. with a 245-30-22 or a 255-30-22. make sure your wheels are 5x127 (5x5)
Install a electric air fan(s),set tires psi to manufactured specifications air filter ,get rid of extra weight ,change fluids to synthetic,go to posted speed limit ,get a vacuum gauge ,
DANGER: Do not cut a hole to remove the fuel pump. Good way to start a fire and possibly kill yourself. If there is not an access panel factory installed then you will have to drop the tank in order to replace the fuel pump.
On models with a carburetor is is located under the hood, center, upper engine area, mounted on front side of carburetor. On models that are fuel injected it is located under the hood, driver side, lower engine area, mounted in fuel line.
there is usually a button under the steering wheel under the panals that looks like a car lighter when you remove it if you pull the thing out maybe extend the wires and move it closer to the steering wheel you have to press that button and turn the key over at the exact same time and that should bypass the theft system i don't now if that's exactly the way it will work for you but i have a 92 elderado and that's what i had to do woth a try good luck
To replace the belt on a Cadillac Eldorado, first ensure the engine is off and cool. Remove any necessary covers to access the belt, then use a wrench to relieve tension on the tensioner pulley and slide the old belt off. Before installing the new belt, refer to the belt routing diagram typically found on a sticker in the engine bay. Finally, position the new belt over the pulleys, ensure it's properly aligned, and reapply tension to the tensioner.
Created By was created in 1993.