Want this question answered?
Electrical equipment that is defective should be where possible repaired and if not repairable it should be replaced.
Testing and wiring should be carried out by a qualified , trained technician / engineer so that the electrical devices and wiring are properly done with safety.
ammeter
it should always be slightly more than 2* length of electrode GI pire l*b*H should be of (2.5-3)m*60mm*13mm
maybe you will get electrocuted?
Test and inspection of electrical equipment should always be carried out when commissioning . This will done before voltage is applied , usually known as dead testing to verify the suitability . Live testing will then be carried out to confirm compliance with regulations .
Verify that the power is turned off before any work is started on electrical projects.
Yea if you don't your electrical boxes will be to deep for your device
To start from basics... Fuses.
To start from basics... Fuses.
yes
1: Identify sources of supply 2: Isolate 3:Secure isolation 4:Test the voltage tester 5:Test the equipment is dead 6:Test the voltage tester 7:Begins work
The primary precaution when working on any capacitor is to ensure that the capacitor is disconnected from electrical sources and that it has been fully discharged.
If the power is on that gives this unit electricity, than you must keep all metal away from it, for it may cause an electrical shock. If you are working on the electrical unit and you need to use metal, then shut the power down.
No-one should work on live electrical equipment without training, and the training would answer that question. Always turn equipment off and unplug before doing any work.
The main reason why you should avoid bodily contact with ground while working on live electrical equipment is that such contact will complete a circuit. If you are in contact with any electricity, this means that your body becomes part of the path for the electricity and it will pass through you as it heads into the ground.
One should hire an electrician if there is electrical work to be done that requires a professional. For example, faulty wiring or the fitting of wall sockets or extra lighting would require a qualified electrician and that work carried out complies with Part P of the building regulations issued in 2005.