In a boat: when the hull is filled with too much water and the vessel is riding too low in the water. The bilge pump will pump the water out. Water can get in the hull through minor cracks or seaspray coming in through the top of the deck
A bilge pump is a small pump fitted in ships to pump the bilges clear of water.
A bilge pump is a small pump fitted in ships to pump the bilges clear of water.
No the law does not require you to have a bilge pump, but on larger boats it is foolish to not have one.
A "bilge pump" is not automatically on a boat. Every boat does however have a bilge area. It is the area in a boat's hull where water collects. This area is seriously recommended to have a "bilge pump" in it on every boat to pump the water out of this area while on the water. Bilge's have drain plugs on the back of the boat for when you take it out of the water to fully drain it.
probably not because of the way the valves are in the pump but it would be funny if that happened
A muffling device
bilge pump
If your engine is a sportjet, it probably has a bilge siphon system that connects to the pump. If so, the siphon hose must be "looped" from the pump above the water line, then back down to the bilge. This should prevent water from backwashing through the hose into the bilge.
A bilge pump does not run continuously. If you have one that is running all the time it is not working properly. Running all the time will wear it out.
Bilge pump.
A Bilge Pump is what it is referred to on ships when you pump water over board. Trash pump.
IN larger boats, the area at the very bottom of the boat is called the "bilge", and the water there is sometimes called "bilge water". To get rid of it, sailors use bilge pumps to pump the water over the side and out of the boat. For smaller boats that don't have bilge pumps, the sailors will "bail" the water out by scooping it up with any suitable container, and dumping it overboard.