Something called a blower control module takes the place and is found in the hole where you would find a blower resistor, so there isn't a blower resistor in that vehicle. As far as the blower control module is concerned, the module is serviced as a unit. No part can be fixed or replaced. This is not to be confused with the control head in the dash. The blower control module is held into the heater box with two 8mm screws outside the firewall under the hood, where you would normally find the blower resistor pack.
It may only be the resistor pack or the resistor module depending upon your climate control type.
The blower motor speed resistor is burned out. You can replace only the resistor but the resistor probably burned out because the blower motor is going bad. If you want to fix it for good, replace both the blower motor and blower motor speed resistor.
On the auto temp unit it is called a blower power module.
Check to see if you are getting power to blower motor - if so replace blower motor If not check fuse, switch, resistor pack.
Check to see if you have 12 volts at the blower motor. If yes then the blower motor is bad. If no, then the resistor, relay, or fuse is bad.
To replace a blower motor on the resistor first you take off the nozzle and then you go into the motor through the nozzle and unlock it then repeat and oil and done.
Take the glove box out then behind it if you listen you can find the blower mtr not all the facts but its how far I got
# Locate the blower resistor under the right-side of the instrument panel # Disconnect the electrical connector from the blower motor resistor # Remove the blower motor resistor mounting screws and remove the resistor from the housing # Installation is the reverse of removal
Sounds like blower motor module resistor
What model? This probably has electronic Climate control,therefore there isn't a Blower resistor. The blower is controlled by a Blower Motor Module...its mounted on the HVAC case under the hood near/next to the blower motor.
replace the blower motor switch
you need a new blower motor resistor with auto temp control