0
This sounds like a mixer type faucet as it was not stated. However, this is a common problem and it lies in the o rings of the cartridge which have dislodged. Either you need to remove the cartridge and realign the o rings, or replace the o rings or get a plumber to do it for you.
What else can I help you with?
Why are my pipes vibrating and then when I start to open the faucet up it stops?
The vibrating pipes could be due to water hammer, which is caused by a sudden halt of flowing water in the pipes. When you open the faucet, the water starts flowing smoothly again, eliminating the water hammer effect and stopping the vibration. Installing a water hammer arrestor can help prevent this issue.
what is a spigot?
Its the faucet handle
Can a gold plated faucet be repaired if it chips?
Yes, a gold plated faucet can be repaired if it chips. It is likely that you will need to have the faucet re-plated in order to make it look new again.
What is the best way to tighten a loose sink faucet using a sink faucet wrench?
To tighten a loose sink faucet using a sink faucet wrench, first turn off the water supply to the faucet. Then, use the wrench to tighten the nuts underneath the sink that secure the faucet in place. Be sure to tighten them evenly and securely to prevent the faucet from becoming loose again.
How to Install a Water Filter on Your Faucet?
Installing a water filter on the end of your kitchen faucet is very easy to do and allows you to use filtered water for all of your kitchen needs. Every type of kitchen faucet water filter is attached in a similar fashion, though there may be some specific details that are different with your particular faucet or filter. Remove the Original Faucet End The first thing you need to do is take off the end of the faucet. You can usually unscrew it with your fingers. If it is very difficult to break loose, use a small wrench to give it a little more strength. Wrap a dish towel around the end of the faucet before you use a wrench so that you will avoid scratching the faucet’s surface. Once the end comes off, there may be some rubber washers that come off as well. Set these aside so that you can find them again later if necessary. Assemble the Water Filter Most faucet water filters are not fully assembled in the box. Take all the parts out of the box and put them together according to the instructions that should have been provided. In general, you will probably just need to put the actual filter into the filter housing so that the water will flow through properly. Do not use a great deal of force when you put the unit together. Most plumbing appliances are meant to be tightened by hand so that they can be loosened easily when you need to remove them again. Find the Right Attachment for Your Faucet The water filter will come with faucet attachments that are different shapes and sizes. Test each attachment until you find the one that screws on to the end of your faucet easily. Make sure that the attachment is lined up properly when you screw it on. Trying to screw it on at the wrong angle can make new impressions in the threads of the attachment, which will allow water to escape once the faucet is turned on. When you find the right attachment, put it on the water filter and then screw the entire assembly onto the faucet.
How do you get air out of a pipe so the water for the faucet will run full again?
A Hoffman #75 air eliminator
How do you stop a faucet from sputtering?
Often a faucet will sputter if there is air in the lines. This happens if the water has been turned off and then on again. If this is the cause, it is only necessary to run the water a while and the air will get out of the lines, and the sputtering will stop.
Are gel kitchen mat's easy to clean?
Yes, gel kitchen mats are easy to clean with a sponge, soap, and water. You can let these air dry and then you can use them again and clean them again easily!
Which onedirection song was written by singer ed sheeran?
little things moments over again
Can you use two water supply ouy lets with faucet?
There are always two hoses connected to a faucet. Hot & cold will have their own valves & stainless lines. (1) to each side. It's an easy hook up. Just turn off both valves, connect new faucet the same way & turn them on again.
How do you unclog a bathtub faucet?
Get down into it with long thin tweezers and pick all that yukky hair out. Buy a hairscreen and it won't happen again.
Where can I purchase vintage Kitchen-Aid mixers?
Vintage Kitchen Aid mixers pop up now and again at estate sales and tag sales. Kitchen Aid issues a new model with a "vintage design" now and again. There is actually little variation in the design (compared to the newer models), but the colors are different.
